J. LOUIS HILE II
aczdhj@r.postjobfree.com
Current Address: Permanent Address:
*** ***** ****** *** ************ Drive
Altoona, PA 16601 Middletown, PA 17057
OBJECTIVE
To be a part of an organization where I can fully utilize my skills and make a significant contribution to the success of the employer and at the same time my individual growth.
EDUCATION
Penn State Altoona
Bachelor of Science, Electro-Mechanical Engineering Technology, May 2017
AutoCAD Certificate - May 2015
COMPUTER SKILLS
AutoCAD, SolidWorks, Creo Parametric,
Creo Simulate, Microsoft Offices, MasterCAMX7, Advanced Programmable Logic Controllers (Logix5000), MATLAB
COURSE WORK
Thermodynamics, Automated Control Systems, Op Amp & IC Controls,
Fluid Mechanics, Electric & Mechanical Drives, Embedded Processors
PROJECTS
Senior Project - 42 LED Strips in a hollow table, powered by four 5V battery supplies, programmed by an Arduino (Teensy) for pulsing/waving to music, it can also project slideshows and short clips
Mechanical Project- Created a 3D model plane using Creo Parametric and Creo Simulate to build and stress test the plane such as fuselage, wings, body and propeller before building it using a 3D printer
Electrical Project - Electrical motors where I had to stop using torque that would push it over the amperage and ruin the circuit board, MATLAB and Simulink was the software used.
WORK EXPERIENCE
Pennsylvania Department of Transportation Harrisburg, PA
Materials Testing Lab Intern May 2016 to August 2016
Tested asphalt samples for Construction Percent within Limits (PWL).
Exel Logistics Mechanicsburg, PA
Projects Internship – May 2014 to August 2014
Produced a study of work flow to establish efficient standard operating procedures
Operator – May 2013 to August 2013 and December 2013
Forklift Certified, responsible for completing customer orders