Electrical Maintenance Technician

Eric D. Mason

**** ****** **** ** ********, IN, 467**-***-*** 8125 acyi52@r.postjobfree.com

Objective

To obtain an entry level job as an industrial maintenance technician or electrician

Education

JANURARY 6, 2014 TO PRESENT, TRINE UNIVERSITY

Major: Electrical Engineering

Related coursework: AutoCAD, electrical circuits. Plc programming with rs logix 500 and 5000. Electrical hydraulic and Pnuematic schematic reading, wiring and comprehension.

January 7, 2009 to June 3, 2012, Northwest State CC

Major: Industrial Maintenance and Applied Technology

Related coursework: AutoCAD drafting, Electrical print reading

Experience

ELECTRICAL CONTROLS TECHNICIAN/ MAINTANENCE CJ AUTOMOTIVE OCTOBER 12, 2015 TO PRESENT

Working with hydraulics, pneumatics and electrical systems on a daily basis. Fabricating new concepts and updating electrical systems as needed. Working with rs logix 500 and rs logix 5000 to make adjustments for outdated analog technology. All aspects of programming and troubleshooting slc and micrologix plcs. I run conduit, replace hydraulic and pneumatic valves, use logix to adjust program etc. Working with fanuc abb and motoman robots. Performing weld modifications and point touch up.

ELECTRICIAN CREATIVE LIQUID COATINGS JULY, 2015 TO SEPTEMBER 29, 2015

CONTRACT JOB RUNNING CONDUIT, ADDING NEW COMPONENTS TO ELECTRICAL BOXES. ON A DAILY BASIS I WOULD USE LOCKOUT/ TAGOUT AND RUN WIRES FOR 120, 277, 480 VAC. ALSO WORKING WITH 24 VDC.REPLACING OLD MOTOR CONTACTORS, ADDING UPDATED SAFETY RELAYS, AND REPLACING SERVO DRIVES AND MOTORS.

MAINTANENCE TECHNICIAN TI AUTOMOTIVE DECEMBER 21, 2013 TO JUNE 26, 2015

TROUBLESHOOTING AND REPAIR OF HYDRAULIC, PNUEMATIC, AND ELECTRICAL SYSTEMS. ON A DAILY BASIS I USED LOTO, PRACTICED SAFE WORK HABITS,ETC. I WORKED WITH PNUEMATIC BENDERS, ABB AND FANUC PICK AND PLACE ROBOTICS SYSTEMS EVERY DAY. FABRICATION AND WELDING SKILLS USED DAILY. ADJUSTING HYDRAULIC CRIMPERS, CHANGING LINES AND FITTINGS.