Anthony Joseph Cronin Jr.

***** ***** **** ****

Dade City FL, 33525

Cell:352-***-****

Subject: Manufacturing Engineering

Below is a short out line of my Boeing Manufacturing Experience built on a University of Florida (Class 1995) Bachelor Science Electrical Engineering Degree and 11 years Aviation Electrician (E-6) United States Navy Technical knowledge/experiences. Thank you for consideration.

• Firm Manufacturing Engineer F/A-18E/F Low Rate Initial Production LRIP through to Production on the electrical design team designing tooling for aircraft wiring harnesses for supplier and resolving aircraft manufacturing installation issues for aircraft wiring harness installation.

• Technical Editor/Writer for maintenance publications F/A-18 for five countries, F-15 for three countries and AV-8B.

• Integration Software Test using Software Design Documents SDD and Interface Control Documents ICD writing test documents for milestone functional capability meetings.

• Senior Software Design Engineer writing risk cube issues and addressing the suppliers functional capability to program schedule at subcontractor/suppliers manufacturing plants

University of Florida Class 1995 Bachelor Electrical Engineering

• 60 college courses, UFID# 8133-6300, UF GPA over 2.91,

• 29 UF Engineering Courses, Lower Level GPA 3.7

Navy Technical Knowledge E-6 Aviation Electrician

• Jet Engine Functional Test Facility Quality Assurance Operator/Inspector on six different Jet Engine Types

• Maintained Aircraft Helicopter/Jet-Aircraft: power generation distribution, lighting, navigation, flight control, landing gear electrical control, and instrumentation: fuel quantity, hydraulic, airspeed, altitude, attitude.