Welder/mechanical assembler/forklift driver
Resume:
U’Rico Chism
Houston, TX 77040
**********@*****.***
OBJECTIVE: SEEKING A POSITION IN A PROMISING DRILLING ENVIROMENT WHERE I CAN APPLY MY KNOWLEDGE ABILITIES AND EXPERINCE TO PERFORM THE SATISFACTORY DUTIES IN THE OIL FIELD.
WORK HISTORY
National Oilwell Varco, Downhole Houston, TX 936-***-****
Mechanical Assembler/Welder
09/2014-02/2015
Assembled equipment used in the exploration and maintenance of oil wells such as bumper Sub motor, internal/external tubing cutters, scrapers, jars, HM motors, coiled tubing motors, junk baskets and fishing tools.
Extensive use of Griffing torque master machine, tested machinery and close tolerance tools for downhole tools. Used overhead/small cranes, forklift truck and walking manual forklift.
Read blueprints, diagrams and instruction manuals during the process of assembling tubing motors and machinery.
Performed fabrication on steel down hole tools.
Tranter heat Exchange Houston, TX 281-***-****
Assembly Tech
03/2013-08/2014
Read blueprints, drawings and schmetics to assemble steel units for break down to clean and troubleshoot repair upgrades. Cleaned/checked plates for damages and rust corrosion in the heat exchanger.
Performed Hydro and Air pressure testing by operating valve shut off meter. Used deburr and grinder parts for inspecting plates and welds for the heat exchange units.
Performed structural welds and pipe fitting using MIG and STICK while welding on iron and steel.
Ryan Technologies Houston, TX 281-***-****
Tool Crib Attendant/Assembler
10/2011-02/2013
Insured proper function of all tools built such as pulsers, gamma and directional modules.
Performed Quality controls/safety checks and maintained inventory on all incoming/outgoing tools.
Wrote purchase orders and performed cycle counts on outgoing tools.
Used calipers to rebuild batteries and repaired wire line tools for drilling.
Operated band saw grinder and deburr.
Lone Star Pipe Houston, TX 281-***-****
11/2001-08/2010
Machine operator/inspector/NDT Tester
Operated overhead crane and seat down forklift.
Operated machinery to refinish pipe and roll out steel material, and MIG welded steel coil rolls together to produce pipe.
Prepared steel pipe for inspection by pressure, manual and visual testing.
U’Rico Chism
EDUCATION
Industrial Welding Academy, Houston, TX
12/2013-1/2014
Structural/Stick Welding training(SMAW)- plate welding process in 1g,2g,3g & 4g for flat, horizontal, and overhead positions.
Pipe Welding training, plate process 6g
A&B Crane Services- operator/safety forklift training May 2014
OSHA training course, December 2011
JEFFERSON HIGH SCHOOL- DIPLOMA JEFFERSON, TEXAS
Contact this candidate