Engineer Electrical

LOC VAN TRAN

**** ***** **.

FORT WORTH, TX *****

PHONE : 682-***-****

EMAIL ADDRESS: *****@*****.***

OBJECTIVE

Seeking a position in the field of Electronics Engineer Technician

EDUCATION UNIVERSITY OF TEXAS AT ARLINGTON, Arlington, Texas.

Bachelor of Science Degree in Electrical Engineer

COMPUTER SKILL

Microsoft-Office', Windows', Excel, Access, Power Point, AutoCAD, Lab View, PSPICE, Fortran & C program.

EXPERIENCE

03/15- 4/16 Electronics Technician

Worked in ISG-Service Group, Arlington Texas.

Test and diagnose electronics circuits and components on PCB of cell phones, Iphones and Galaxy, Tablet, handheld CN3.

Used the electronics equipments for measured and tested the signals

Reading schematic diagrams, and other engineering prints to troubleshoot on the PCB by using SMT, through-hole, flow technology and solder

Replaced the parts to components level.

Used the hand tools and other tools to do repaired

Ordering the parts as needed

09/11-01/13 Electronics Technician

Worked in a ATC company, Fort Worth, Texas

Analyzed cell phones problems in the audio signal to determine method for corrective actions.

Using the tools (screws drivers, small hand tools) to assembly and disassembly

Test and diagnose electronics circuits and components on PCB

Set up and installing the software (Flash, decoding, testing)

Troubleshoot the electronics circuits on PCB by using SMT, through-hole, flow and reflow technology and solder.

Utilized the electronic/electrical test equipments such as Power Meter, Volt Meter, Ohm Meter, measuring and testing.

Perform final test to make sure the quality products, calibrate RF, flash programming and set up test procedure

05/07-12/10 Electronics Engineering Tech.

Worked in A NoVo Inc. company, Fort Worth, Texas

Test and diagnose electronics circuits and components on PCB of cell phones

Ordering the parts, tooling, equipments and training of production operators as needed.

Inspection and/or quality audits the products.

Set up and training new employee as the company’s goal

Doing surface-mount technology, SMT, through-hole, flow and reflow technology and solder to repair the PCB

01/04-09/06 Electronics Technician.

Worked in RecellurWireless Inc. Company, Fort Worth, Texas.

Test and diagnose electronic circuits and components on PCB of cell phones.

Applied the surface-mount technology, SMT, through-hole, flow and reflow technology and solder to trouble shoot cell phone

Assembled surface-mount components onto PCB by using reflowing

Utilized the electronic test equipments for measuring and testing signals.

02/01-05/02 Electrical Engineer (Components Engineer)

Worked in Textronics, Dallas, Texas.

Using the Manex Software for design the B.O.M. (Bill of Material).

Control the AVL and ECDN.

Testing and troubleshooting electronics circuits and parts

Technical support for Radio Frequency Engineer Group and Lab-research

Upgrade and modification the schematic for remodel and repair

Determine root cause of problems and initiate corrective action.

Work with the active, passive components and integrated circuits on analog/digital basis with various assemblies Techniques such as

Wiring, Soldering (Through-Hole/ SMT)

Check out the final quality and report the cost of the products included labor and parts.

Support production line, and corrective action of components failures.

Contact this candidate