Control Design

Chentian Weng

*** ********** *** ***: C 38-949-***-****

Elyria, OH 44035 ************@*****.***

Education University of California, Irvine, CA M.S. in Electrical Engineering GPA 3.3 /4.0

Graduate date: March.2013

Wuhan University of Science and Technology, Wuhan China B.S. in Electronic Information Engineering GPA 3.5/4/0

Graduate date: June 2011

Skills

Familiar with embedded system, ability to program based on Microcontroller

Familiar with simulation technical software, such as Matlab/Simulink, TruckSim, ControlDesk, LabVIEW

IC test and design

Integrate circuit layout(Cadence)

Familiar with the use of data acquisition system, such as CANalyzer

Knowledge

Control Engineering Concept and Theory

Information theory

Electronics concept and theory

Knowledge about computer hardware

Professional practice

Hill Safety Assistance HIL(Hardware in Loop) implementation July.2015~now

Set up HSA hardware in HIL lab. Build the transmission control algorithm and HSA control algorithm into Simulink models. Design GUI using ControlDesk and link the Simulink models with the ControlDesk. Download the model into dSPACE board and run it in real time.

Trailer RSP test design Jan.2015~Dec.2015

Build the truck model in TruckSim. Set up inputs and outputs in TruckSim model. Using a servo motor to generate yaw angel. Design GUI using ControlDesk and link the models. TruckSim send signals to dSPACE board and convert them to AC signals and send them to motor controller to control the motor generating yaw angel.

TPMS(Tires Pressure Monitor System) HIL(Hardware in Loop) implementation Jan. 2015~May.2015

Design hardware including different pressure and temperature sensors and interface with Bendix “Smart Antenna ” Write automation test scripts to test TPMS system.

Vehicle ESP, ABS baseline development and test Aug. 2013~2014

Write automation test scripts using MATLAB to automatically control TruckSim models to do ESP manual and automatically change the road surface in TruckSim to do ABS manual.

Researching on energy efficiency with professor Ender Ayanoglu Dec.2012~May. 2013

Wrote thesis about using Control Theory in MIMO (multiple inputs and multiple outputs) communication area. Discussed the solution to decrease SNR(signal-noise-ratio) in this thesis.

Design flash ADC with the help of professor Kleinfelder March.2012~June 2012

Designed the ADC (analog to digital converter) integrate circuit. Run the simulation to make sure it satisfied the requirements. Layout ADC integrate circuit. Send the IC layout to IC production factory. Test the chip.

Design and test DC/DC.AC/DC converters with professor Smedley Jan.2012~Mar.2012

Design the DC to DC converters and AC to DC converters using different topological graphics.

Designed solar tracking system basic on different hardware platforms with professor P.Chou Sep.2011~Dec.2011

Build the control model and load it into microcontroller. Use photosensitive resistance sensor to catch the light from sun and covert light signal to electrical signal and sent to the microcontroller. The microcontroller will control the motor to track the sun.

Intern

Broadcom in Irvine

Duty: integrate circuit layout Nov 2012~ Mar. 2013

Department of testing of Nokia cell phone company in Wuhan branch

Duty: testing the RF circuit and the cell phone June 2011~ Aug 2011

Current job

Information about current employee: Bendix Commercial Vehicle System, LLC (Start from 29th July 2013)

Job responsibility: * Develop and modify control system logic to support Electronic Systems, including Antilock braking, stability control and driver assistance/adaptive cruise control systems installed on commercial vehicles.

* Create Software for Embedded systems and tools that support Embedded systems.

* Apply vehicle knowledge to improve vehicle simulation tools including both non-real time and Hardware In the Loop (HIL) simulation.

* Prototype new control algorithms

Contact this candidate