Electrician Electrical

Sylvester Roberson

Electrician

Columbia, SC

**************@*******.*** - 803-***-****

An interesting position with a growing company

Authorized to work in the US for any employer

WORK EXPERIENCE

Electrician

Berg Electric - San Diego, CA - October 2013 to September 2014 Eric Ayers 803-***-****. This job was located at Ft. Jackson. There I ran conduit of various sizes, pulled mc cable, installed panels, terminated panels, installed fixtures and devices. There was also low voltage and fire alarm work and some troubleshooting. I also did the site lighting. Electrician

Tradesman International - Columbia, SC - December 2010 to July 2013 Print reading, laying out, installing conduit and me cable, installed devices and switches, installed lights and fans. This job was located at Ft. Jackson at the new Drill Sergeants' barracks. Also did a dormitory for U.S.C Electrician

Hunter Specialties inc - Summerville, SC - April 2010 to October 2010 Bill Phillips 843-***-**** Reading blueprints and laying out for installation of conduit.MC cable and, boxes, pulling feeder cable and wire. Installing devices and fixtures also, troubleshooting. Installed panels arid terminated them.

Electrician

Aerotek - Columbia, SC - December 2009 to March 2010 Sam Washington 803-***-**** Substation work, installing 2-3 1/2" rigid conduit, pulling cable [350&500].

Electrician

Labor Source - Charlotte, NC - July 2009 to November 2009 Installing pvc and rigid conduit for slab. Reading blueprints and determining where to install conduit also pulled jet line.

Electrician

Vester Electric - Columbia, SC - February 2008 to June 2009 For the past year or so I've been upgrading services on residential homes, also Installed wiring, devices, light fixtures, receptacles and ceiling fans. These tasks were performed on add ons and remodeling jobs. Electrician

Hinds Electric - West Columbia, SC - February 2007 to January 2008 Planned layout, installed and repaired wiring, electrical fixtures and apparatuses. Measured, cut, bent, threaded, assembled and installed electrical conduit, using tools such as hacksaw, pipe threader and conduit bender. Tested continuity of circuits to ensure electrical compatibility and safety of components, using testing instruments, such as ohmmeters and voltmeter.

Contact this candidate