Technician Mechanical

*** ***** *****, ***** ******, NJ ***** 973-***-**** *********@***.***

Ernest Catucci

Objective

To obtain a position in electronic manufacturing that will allow for career growth and development

Experience:

2013-Present Kearfott Corporation Little Falls, NJ

Electronic Technician

Assisting engineers to customize cable assembly, test equipment, module, control box, shielded and solder sleeving cable assembly, printed board assembly, and mechanical assembly.

Drill holes on chassis, marking, crimping and soldering.

Cable assembly per blueprint.

Mount components bottom chassis, rear and front panels

Mark chassis and panels

Crimp pins on connectors

Visual Inspection

Wire per schematic and form harness layout, tie lacing cord, nylon tie wrap and to be soldered on component level

Continuity and Functional testing

Repair, remove and replace defective components

2001 – 2013

BAE Systems

Wayne, NJ

Electronic Technician

Assemble, repair and replace electronic components, assemblies, subassemblies and modules by working from samples, visual aids, prints, wiring lists and diagrams, routing instructions and process sheets using appropriate tooling and machinery. Assemble parts using fasteners in the build-up of electronic assemblies. Verify results to ensure conformance with requirements and performs rework as needed.

Perform mechanical assembly operations in the build of electronic assemblies using standard measuring tools and techniques.

Perform electronic assembly operations such as wire termination, and installation of wire harness, cable assemblies, relays, transformers, capacitors, resistors or other electronic components.

Fabricate wires on a Jig Board (Harness Board) in accordance with specifications. Continuous laces, flat laces and spot ties wire into bundles and routings according to drawing requirements.

Prepare wires by performing the following tasks: routes, dresses and terminates conductors to specific dimensions as specified by instructions.

Pre-stage circuit card kits and forms components by use of machine and hand devices, which meet general requirements and Manufacturing Control Specifications (MCS).

Perform masking operations prior to wave soldering or coating of circuit card assemblies (CCA). Cleans boards per Manufacturing Control Specifications (MCS).

Experienced in the Logistics processing

Also microscope experience

1992 – 2001

Aeroflex (formerly KDI)

Whippany, NJ

Senior Electronic Technician

Managed the electronic assembly of components including wiring and printed boards,

Assembled prototypes and mechanical housing.

Team leader of 3-6 workers.

Experience with hotplate soldering including microscope.

Responsible for tracking sheet.

Education

1975

R.E.T.S.

Nutley, NJ

Electronics

Skills and Certifications

Secret Clearance, Certification wiring and printed boards, IPC-610, ISO 9000, MIL-STD-454D, MIL-STD-1686, NASA wiring and NHB 5300.4 PCB.

Contact this candidate