Project Electrical

Location:

Posted:

March 06, 2015

Joanna Baqadi

Education:

BS Degree Electrical Engineering UC San Diego Graduation: 07/2015

Objective: Seeking a full time Electrical/Test engineer position.

Skills:

C,java,Matlab, and Arm assembly Knowledge of Project Navigator logic gates,

Software and Hardware Testing. schematics and simulations.

Linux/Windows Operating Systems

Design and Simulation of Analog and Digital Excellent in designing, debugging, and problem

Circuits. solving of analog circuits.

Excellent in Schematic, Simulations layout of PSPICE schematics simulations.

VLSI Circuits and by Cadence

Software Testing Networking - TCP/IP protocols

Diodes, CMOS, and BJT circuits and simulations. Knowledge of oscilloscope analysis.

Work Experience/Projects:

San Diego Sound Solutions &Technology - Electrical Technician May 2014 - September 2014

-Designing, routing, and networking telecommunication systems, security surveillance, audio and

video systems for the new Chinmaya Temple- Poway, California.

-Utilized specialized low-voltage tools and equipment including required list of tools to perform

daily tasks.

-Patch panel construction, coaxial and CAT5 and CAT6 cable installation, terminating and

troubleshooting.

-Negotiated design and placement of server networks, video cameras, and other electrical

installations in such a way as to optimize space sharing, minimize potential safety hazards, and

maximize optimize efficiency.

FTP : an FTP client in C was written libcurl library. When the program is run should present the user with get

a remote directory listed, send a file, receive a file, and exit.

8-B it Carry Skip Adder Design with zero Carry-in: A hand- design of the schematic, transient analysis and

layout of an 8 bit adder was done by cadence. By designing half adder, full adder, multiplexer form simple

logic gates, and organize them in speed performance and small blocks in an official way, the project was

accomplished successfully. The 8 bit adder was with high performance that is utilized in industry field.

Delay Effect: the project was done by ARM assembly language. A delay effect was implemented on the

LPC2148. Analog to Digital Converter (ADC) was used to convert to take samples from the microphone delay.

The samples was delayed by0.25 seconds, and played them back through the headphone port.

SHA-1: The project was done by Verilog. In the first step the bits were padded. Then the length was

appended as 64 unsigned bits. After that buffer was initiated by initializing message digest (MD) to

five 32 bit words. Finally the algorithm was written.

Others: Designing Linear Circuits system and analysis with PSPICE and matlab DSL Low-Pass

Filter, Voltage Follower, Differentiator, Ring and Relaxing Oscillator Design, and analyze circuits.