Maintenance Cnc Programmer

RESUME

Name: James Everhart

Address: **** ***** ***** **** #**, Brownstown, IN 47220

Telephone: 812-***-****

Email: *********@***.***

PROFILE

Over 20 years’ experience as a Press Operator, CNC Operator, Machinist

Programmer and a Quality Supervisor( including NDT testing). Seeking a

position with a company where I can use my skills and abilities to make a

difference within the company’s growth.

CORE COMPETENCIES

Work with Systems Bobcat Operations

CNC Programmer Drill with Peck Speed and Feed

Quality Supervisor NDT Testing

EXPERIENCE

Valeo A Avenue, Seymour, IN.47274

7/17/2013-present

Press Operator

• Take headlights off the line

• Inspect housing for no fill, broken pins and other defects

• Trim excess flash and assemble adjuster and screws

• Inspected bezels for no fill, broken pins, splay and contaminants

• Trim flash, load in VTI and aluminize

• Unload and inspect for black or white spots, scratches, and pack to

specifications

Arvin Meritor 5212 Hwy. 42 East, Carrollton, KY, 41008

3/2002-10/2009

Maintenance Helper

Repair conveyor bearings, chains and gears

I worked on Hydraulic Hoses, Pumps, Seals, DCV Valves, Pressure Valves

and Control Vales

I worked on Electric contact switches, electric connections, limit switch’s, test

fuse, electric current and capacitors

I worked as an induction helper to pull new lines

Bobcat operations; fork truck and cranes

Changed oil and filters, clean air filters clean up oil and contaminates

Drained and cleaned reserve tanks and lines, drain off water off pneumatic

I worked on preventative maintenance

KINCO South Obrien, Seymour, IN. 4727

4/1994-

9/2001

CNC Programmer

Write Programs, geode cutting speed and feed

Drill with peck speed and feed

Tap feed rate

Tap check with calipers, mic and digital readout

Square up block from rough cut

Lathe and precision grinders, bridge ports

I made all setups by blueprint layouts

I checked hole locations to be drilled, taped or cut and diameters

NORTH VERNON FORGE North Vernon, IN.

4/1976-9/1991

Maintenance/ Quality Supervisor

I worked for one (1) year with Hammer Mill

I worked for three (3) years in maintenance

I worked for two (2) years as part inspector to blue print specifications

I worked for seven (7) years as Quality Supervisor

Blue prints, layout with calipers, mic, optical comparator

Set gauges for angles

Hardness and softness (Bam ell)

Check for cracks, air holes outside and inside

NDT Testing

I had to deal with problems inside the plant and at the customer

locations

I made decisions as to what had to be done to correct the problems

I had to figure out what to change in the process to reduce defects

EDUCATION

IV TECH, Madison

Associate Degree – Applied Science- Industrial Maintenance Field

7/2012

Certification - Industrial Maintenance – Industrial Maintenance Field

Certification - Fluid Power – Industrial Maintenance Field

2011

Industrial Maintenance & Fluid Power

MAGNFLUX, Indianapolis

1982

4 CEU – Ultra sonic

2 CEU nondestructive testing (NDT)

Contact this candidate