Maintenance Quality
Resume:
Scott Allen Rallis
Home: 615-***-****
Lebanon, Tn. 37087
Cell: 603-***-****
E-mail:
**********@*******.***
Education
Ross E. Jeffries Elementary
Vol State Community College
1963-1967
1986-1988
103 Wisconsin Ave.
East Nashville Hwy.
St. Cloud, Fla. 34769
Gallatin, Tn., Preliminary studies
St. Cloud middle School
Ashford University
1968-1970
2008-2011
1110 10th St.
San Diego, Ca.
St. Cloud, Fla. 34769
Healthcare Administration
St. Cloud High
1971-1975...graduate
1769 Indiana Ave.
St. Cloud, Fla. 34769
Work History
Wal-Mart
03/2010-09/2012
Billy Dean (Mgr.)
Duties; Unload trucks, stock merchandise in designated departments,
light maintenance, and general clean up.
Equipment; Forklift, pallet jack
Reason for departure; FMLA required lengthy time off. Mutual parting,
and am eligible for rehire.
Orchid International LLC
04/2002-11/2009
Doug Miller (Production Mgr., Immediate Supervisor)
Duties; Set dies in appropriate presses (50-1000 ton), program smart pac
system accordingly, (parameters, tonnage monitoring, hydraulics etc.)
locate and load steel coil for progressive press run, check off quality
for first piece according to auto part spec prints, and production run.
Four years in pro-duction led to increase in knowledge which opened the
door to tool room apprenticeship. Spent 3 + years sharpening punches,
detail sections, polishing, and general maintenance on top bottom of dies.
Replacing punches, blocks, forms etc. as required. Sometimes need to spin
in house punches down and/or shim up, down as proper die timing required.
As every die and its functions are different, so are the needs and time
spent on upkeep, and repairs. This is my favorite part or phase of the
industry.
Equipment; Remote crane, manual crane, fork lift, pallet jack, in-house
PC, Smart-Pac Programming Systems, Lathe, End Mill, wet and dry grinder,
Angle, protractor, robotic welders, and most all measuring device tools
(micrometers (depth, hight, 0-1 thru 0-12") calipers, slide-rules, compass
etc. wrenches (Allens, metric and standard) hammers, extensive list goes
on.
Reason for departure; Economy, and falling auto industry, ...company had
major lay off, no recall forced me to seek any employment hence opportunity
at Wal-Mart.
International Tooling and Stamping
05/1998-03/2002
Al Hensch (Production Mgr.)
Duties; Run 200 ton press, and perform minor in press tooling as needed,
(replace, or sharpen punches, shim up or down forms, blocks, punches etc.
as needed to maintain quality parts) during runs.
Equipment; Forklift, measuring device tools (micrometers, calipers, rules
etc.), and basic tools for repairs (wrenches, die bars etc.)
Reason for departure; As interest and knowledge of industry
increased...sought better opportunities both in advancement, and wage left
on excellent terms.
Earlier employment history can be provided if needed.
References
Ray Davenport friend/colleague Mgr. retired
Robert Shuttera friend Site
Forman Lee Co. 615-***-****
Contact this candidate