Asif Al Rasheed
Troy, MI *****
906-***-**** ********@***.*** www.linkedin.com/in/asifalrasheed/
Objective:
Obtain a full time position or internship in RF/Antenna Design.
Education:
Michigan Technological University (MTU) Houghton, MI
MS in Electrical Engineering (GPA: 3.89/4.00) August 2014
Relevant Courses: Microwave Technique & Antennas, Antenna Design, Detection and Estimation Theory, Digital
Communications, Wireless Communications, GPU and Multicore Programming, Biomedical Signal Processing
Bangladesh University of Engineering and Technology (BUET) Dhaka, Bangladesh
B.Sc. in Electrical and Electronic Engineering (GPA: 3.85/4.00) October 2009
Relevant Courses: Digital Signal Processing, Control System, Biomedical Instrumentation, Advanced
Telecommunication Engineering, Optical Fiber Communication
Certifications:
CCNA (in preparation, exam tentatively scheduled)
Technical Skills:
Programming Languages: C/C++, Embedded C, CUDA, Assembly Languages (Nios II and 80 86), Verilog, VHDL
Hardware: MPC56xx MCU, TMS320C64X Digital Signal Processor, Altera DE2 Development Kit, Atmel ATmega32,
Altera FLEX10K CPLD, Programmable Logic Controller, MCP4821 DAC, MTS -86C, MDA 8086, Rhode Schwartz Vector
Network Analyzer, Stepper Motor, Display (LCD, 7 Segment), Oscilloscope
Simulation and Design Tools: MATLAB, Simulink, NI LabView, NI Multisim, ANSYS SIwave, ANSYS Simplorer,
ANSYS Q3D Extractor, ANSYS Designer, EM.Cube Suite, CadSoft EAGLE, Mathematica, Orcad PSpice, CircuitMaker,
Cadence Tools, MicroWind, DSCH, AutoCAD
Full Wave Electromagnetic Simulators: ANSYS HFSS, ANSYS Maxwell, CST Microwave Studio, FEKO
IDE: Quartus II, Visual Studio, Altera Monitor Program, PonyProg
Standards/Specifications: Voice over WiFi, Voice over LTE, Voice over IP, LTE PHY layer 3GPP 36 series
Operating Systems and Other Applications: Linux, MS Windows, MS Office
Experience:
MTU, Department of Electrical and Computer Engineering Houghton, MI
Graduate Research Assistant under NSF funded projects Aug 2011 - August 2014
Project: THz Short Range Communications May 2013 - August 2014
Envisioned future and identified current applications of inter- and intra-chip communications including
clock and data transmission in multi core chips and Wireless Network on Chips (WiNoCs)
Proposed approaches for theoretical investigation and simulation in MATLAB and EM.Cube of channel
parameters such as path loss, power delay profile, delay spread, angular spread, beamforming, spatial,
temporal and spectral correlation, fading statistics, antenna and antenna array structures and modulation
and transmission schemes for short range communications in THz band (0.1-10 THz)
Investigated received power in computer motherboard using diffraction theory based ray tracing in
MATLAB and EM.Cube in 100 and 300 GHz. Researched effects of transmitter-receiver distance, height of
transmitter, component population and distribution and number of reflec tions on received power
Project: Impact of Rough Surface on Outdoor Smallcells Aug 2011 - Apr 2013
Derived closed form expression of spatial correlation using Kirchhoff approximation
Evaluated effect of roughness average height, receiver separation, transmitter-receiver distance, transmitter
and receiver heights, roughness correlation distance and ratio of Line of Sight (LOS) to Non-LOS (NLOS)
power on power and spatial correlation for 30, 60 and 300 GHz
Investigated effect of above parameters on power and spatial correlation by ray tracing in MATLAB
Graduate Teaching Assistant Sep 2012 - Apr 2013
Communicated design and construction of I/O devices in Altera DE2 Developm ent Kit to 30 students
Coached NIOS II assembler language, C/embedded C, Verilog, system integration and testing
Primeasia University, Department of Electrical and Electronic Engineering Dhaka, Bangladesh
Lecturer for courses on VLSI, Microprocessor and Interfacing and Digital Electronics Oct 2009 - Apr 2011
Generated course content, laboratory manual and exam questions for a total number of 100 students
Instructed Trained students on using MTS-86C, MDA-8086, MicroWind and DSCH
Asif Al Rasheed, Page 1 of 3
BUET, Department of Electrical and Electronic Engineering Dhaka, Bangladesh
Research Assistant working on undergraduate thesis and projects Jul 2008 - Oct 2009
Thesis: Performance Analysis of Free Space Optical (FSO) Systems over Atmospheric Turbulence Channel
Introduced Intensity Modulation scheme for transmission, Sequence Inverse Keying correlator for reception
and scintillation by gamma-gamma pdf to simulate atmospheric turbulence
Simulated the effect of varying number of users and degrees of scintillation on BER performance of FSO
CDMA and Multi Carrier (MC)-O(Optical)CDMA for different length of non-orthogonal codes in MATLAB
Developed analytical model of Multi Carrier (MC)-CDMA Rake receiver for Rayleigh multipath fading
channel based on Maximum Ratio Combining (MRC) diversity and evaluated BER performance for different
fingers using MATLAB simulation and compared against a conventional MC-CDMA receiver
Robi Axiata Limited (GSM) and Citycell Limited (CDMA) Dhaka, Bangladesh
Trainee with different divisions such as NOC, switching, planning and monitoring Dec 2008
Gained knowledge about VLR, HLR, BTS, BSC, MSC, GPRS and infrastructure of cellular networks
Projects:
Design of an E-shaped Patch Antenna for Local Positioning Applications Sep 2012 - Dec 2012
Devised antenna for 2.45 GHz center frequency, 80 MHz bandwidth, 90 degree beamwidth and low front to
back lobe ratio to be used as part of an antenna array employed in Wireless Local Positioning systems
Calibrated patch and slot dimensions, feed point locations of the antenna through FEKO simulation of far-
field pattern, beamwidth, bandwidth, S-parameter, Voltage Standing Wave Ratio (VSWR) and impedance
Fabricated the antenna on RT Duriod 6002, tested for far-field pattern in anechoic chamber and used Rhode
Schwartz Vector Network Analyzer to measure S-parameter, VSWR and antenna impedance
Optimization of Orbit Transfer from Low Earth orbit (LEO) to Geostationary orbit (GEO) Sep 2013 - Dec 2013
Computed thrust angle history for minimum fuel consumption, 5% tolerance in final velocity and radius of
final orbit of the satellite and perpendicularity of velocity and radius of orbit in final position
Ran pattern search method using initial guesses to meet the constraints and utilized constrained
optimization for optimizing velocity and radius of orbit in MATLAB
Demonstrated satellite maneuver path from LEO to GEO with the computed thrust angles
Time of Arrival (TOA)-Based RF Localization in Wireless Capsule Endoscopy Sep 2012 - Dec 2012
Created simplified but functional human body model in FEKO and used Finite Element Method (FEM) to get
TOA of an endoscopic capsule on its travel inside the stomach, small intestine and large intestine using
different number of sensors and sensor array configurations in the MICS band (402-406 MHz)
Implemented localization using trilateration in MATLAB to get localization accuracy from TOAs and capsule
locations inside the three organs
Compared localization accuracy for different number and/or configurations of sensors and capsule locations
Radar Signal Detection: Amplitude and Time of Arrival Estimation Mar 2012 - Apr 2012
Analyzed signal corrupted by additive Gaussian noise received from distant targets to determine presence
Constructed a correlation receiver with a variable start time and a matched filter to compare their results
Conducted Constant False Alarm Rate (CFAR) Neiman-Pierson hypothesis test for a given false alarm rate
Simulated for numbers of targets, their TOA and amplitudes in MATLAB
Motion Estimation in CUDA Sep 2013 - Dec 2013
Utilized parallelism for 1D and 2D motion estimation in CUDA 2.x for variable block and search sizes
Computed different transfer timings within GPU, tested and benchmarked against CPU in NVIDIA GF100
Improved algorithm and memory efficiency to achieve maximum speed up ratio of 100 or more indicating
100 times or faster performance than compared CPU
Modified Booth Multiplier and Filter design Oct 2009 - Mar 2010
Developed a modified 8x8 Booth multiplier taking into account polarity of multiplier and multiplicand
Constructed the multiplier in CircuitMaker and observed output for different combination of inputs
Designed FIR and IIR filters using MATLAB’s FDATool for desired sampling frequency, and attenuation
Design of Eye Motion Controlled Mouse using ATmega32 Microcontroller Jun 2009 - Oct 2009
Placed solid gel electrodes on the user’s face to detect bioelectric potential due eye movement
Created and implemented Electrooculogram (EOG) biopotential amplifier in CircuitMaker to operate
between 10 Hz and DC to amplify and differentiate eye movement as part of Hardware-in-the-Loop (HIL)
Programmed ATMEGA32 in embedded C to work as Analog-to-Digital Converter (ADC) to communicate with
PC through serial port to demonstrated bioelectric potential and cursor movement in MATLAB
Asif Al Rasheed, Page 2 of 3
Publications and Presentations:
“Rough Surface Impact on Spatial Correlation: 30, 60 and 300 GHz,” IEEE Global Communications
Conference (GLOBECOM), Atlanta, GA, Dec 2013
“A New Approach in the Modeling of an MC-CDMA RAKE Receiver and Its Performance Evaluation
under the Effect of Multipath Fading Channel”, 2010 International Conference on Computational
Intelligence and Communication Networks (CICN), November 2010
"Effect of Atmospheric Turbulence on Free Space Optical Multi-carrier Code Division Multiple
Access," 2010 12th International Conference on Computer Modelling and Simulation (UKSim), March 2010
“Performance Analysis of A Free-Space Optical Code Division Multiple Access Through Atmospheric
Turbulence Channel,” ICCIT, World Academy of Science, Engineering and Technology, August 2009
Poster presentation on undergraduate thesis findings in EEE Undergraduate Project Workshop (EUProW),
Bangladesh University of Engineering & Technology, Oct 2009, Dhaka, Bangladesh
Awards and Affiliations:
NSF Research Fellowship in MTU
BUET Merit Scholarship
Dean’s List in all undergrad semesters
IEEE Student Member
Asif Al Rasheed, Page 3 of 3