Resume

Sign in

Maintenance Technician Engineer

Location:
Sacramento, California, United States
Posted:
December 09, 2018

Contact this candidate

Resume:

Quang Nguyen

Experience

Quanergy System Inc. **/2017-10/2018

Rework Technician

Rework, touch-up, and solder wires point to point.

Remove the components, IC and all other on PC boards if needed by production lines or Engineer require.

Build and use MADLAB Software to test alignment lasers beam, collect data and range test the LiDAR sensors.

BSI Systron 06/2010-08/2016

Process Technician

Document test stations and test procedures.

Maintain and operate txxxxxxxxxest equipment, including benchtop instruments, PXI hardware and software drivers, and other equipment.

Flash Electronics Inc. 09/2004-03/2009

Rework/ICT Technician

Using HP3070 system to test all the functional test.

Troubleshooting and replace all the component if needed.

Apple Computer 04/2002-03/2003

Test/Rework Technician

Primary duties were using software to test and troubleshooting the failure.

Rework and replaced the component on the motherboards.

Integrated Device Technology Inc. 02/1988-02/2001

Maintenance Technician

Primary duties were to maintain and repair electronic / electromechanical equipment.

Troubleshooting analog and digital down to component level.

Complete preventive maintenance and calibration of system, equipment according to the schedule.

Capable of maintaining on line equipment in the high volume production with minimum supervision.

Debug and build the hardware for test engineers.

Northern Telecom 12/1987-01/1988

Test/Rework Technician

Setup network nodes for testing procedures.

Test and troubleshooting to the component modified and repaired.

Rework on through hole and SMT PCB's.

Burnt and program firmware: Prom, EPROM, Pal and Gal.

Education

San Joaquin Delta College

Stockton, CA Major-electronic

AD/DC Theory and Lab, Boolean Algebra, Solid V State Device, Digital Circuit, Microprocessor based system architecture, Physics of Electronics and Basic Program.

Skills

Certificate of Manufacturing Training on System and Equipment

HP, TERADYNE, MEGATEST, SCHLUMBERGER and XINCOM

DELTA FLEX, TEL-P8, TSK-90, SYMTEK and MCT

Soldering under Microscope, rework, and using the volt meter.



Contact this candidate