Technician Mechanical

GLENN W. GERADE

** ****** ****

Reading, MA ***67 781-***-****

December, 2009- December, 2010: ITT CORPORATION, Nashua, NH

Position: Senior RF Technician/Electro-Mechanical Assembler

1. Perform full Electro-Mechanical assembly of modular RFIED jamming system.

2. Involved in final acceptance testing of modules and assuming responsibility for the repair

of modules that fail for infant mortality reasons.

3. Read and comprehend assembly directions from drawings and verbal instruction.

4. Motor skill set includes, but is not limited to RF hard lines (SMA, SMP), harnessing and

connectors, PCB assembly and installation, and mechanical chassis work.

5. Works with tools such as torque drivers, wrenches, and hand-held power tools.

2008-2008: DIAMOND ANTENNA & MICROWAVE CORPORATION,

Littleton, MA

Position: Microwave Technician

1. Performed Assembly Technician I and Assembly Technician II tasks.

2. Assisted in Production floor assemblies.

3. Worked with the Engineering Department on prototypes.

4. Assembled, tested, tuned, and plotted data per specifications.

5. Assisted the Assembly and Test Manager.

7. Performed torch soldering as needed for tuning.

8. Indicated and tuned up concentricity of center conductors to tune the product.

9. Arranged for mechanical and electrical modifications.

10. Used mechanical tools (i.e.-verniers and height gauges).

11. Operated hand tools and measuring tools (i.e.-microscope, torque meter, and torque wrench).

12. Compiled data.

13. Issued stock items.

1999-2006: COBHAM DEFENSE ELECTRONIC SYSTEMS (Kevlin Division), Methuen, MA

Position: Microwave Technician

1. Assembled RADAR using micrometers, calipers, height gauges, indicators, verniers, arbor press, propane torch, heat gun, and microscope.

2. Assembled rotary joints by aligning and fitting parts to required tolerances.

3. In-process inspection of assorted hardware.

4. Pressure tested and torqued units and submitted to Quality Control.

5. Worked with layout drawings, outline drawings, ATS sheets, and ATP specifications.

6. Used a variety of hand tools and power tools.

7. Operated and maintained Paint Department by maintaining spray booths, spray guns, air brushing and stenciling materials.

8. Used computer to generate Bill of Materials, ATS sheets, and ATP specifications.

9. Knowledge of ISO 9000/9001/9002 Quality Standards and Lean Manufacturing Techniques.

10. Followed health and safety rules and regulations.

11. Maintained and organized work areas in a clean and orderly manner.

12. Worked independently from verbal and written instructions

1994-1995: MEDICAL PARAMETERS, Woburn, MA

Position: Medical Assembler

1. Assembled medical intravenous units.

2. Measured and mixed chemicals.

3. Maintained sealing machinery.

4. Monitored and replenished stock materials.

5. Shipping and receiving responsibilities.

EDUCATION:

1983-1987: Northeast Metropolitan Regional Vocational High School

Wakefield, MA

High School Diploma-Certified machinist

REFERENCES: Provided upon request.

Contact this candidate