Technician Mechanical

Michael Ho

Qualifications:

Experience with Mechanical Assembly

Experience with Electro-Mechanical Assembly

HVAC installation experience

Brazing of copper lines

Able to read Blueprint and Schematics

Testing experience

Knowledge of CMM, Hydraulics, Pneumatics, Flowmeter, Oscilloscopes and Multimeters

Able to utilize power supply and hand tools/power tools

Work Experience:

2011-Present

Dan Ho HVAC, Riverside, CA

HVAC Installer (Part Time position)

Assist my brother twice a month in doing HVAC installations for residential homes.

Able to install new ducts, and do leak tests for Freon.

Install new thermostats and do rewiring.

Braze copper lines.

Able to use different tools for installations and a propane torch.

08/2015-02/2016

Circor Aerospace, Corona, CA

Assembly Technician

Mechanically assembled, disassembled, and repaired aircraft components.

Followed blue prints, bill of materials, and instructions for assembling aircraft hydraulic valves and pneumatic valves.

Used hand tools, torque wrenches, open end wrenches, power screw drivers, etc.

Tested with hydraulic flow or nitrogen pressure test.

05/2011-04/2015

Pneudraulics, Inc., Rancho Cucamonga, CA

Assembly Technician

Assembled, disassembled, and repaired aircraft components.

Assembled and tested reservoirs and valve for different type of airplanes.

Assembled and tested hydraulics valves, landing gear and reservoirs for all test gauge.

Set up for test accordance with ATP; analyzed failure and recorded the data.

Followed blue prints from computer and work instructions.

Used hand tools, torque wrenches, open end wrenches, power screw drivers, etc.

Did some electrical work as well using power supplies, oscilloscopes, multimeters, and insulation resistant machine.

Certified soldering training completed.

04/2008-03/2011

Meggitt Defense Systems, Irvine, CA

Assembly Technician

Mechanically assembled, disassembled, and repaired aircraft components.

Assembled and tested thermal management system for military tank and aircraft.

Performed all test accordance with ATP using hydraulics.

Performed documentation work completed and test results.

Troubleshot all system problems.

Read and followed blue prints.

05/2004-04/2008

Pneudraulics, Inc., Rancho Cucamonga, CA

Assembly Technician

Assembled, disassembled, and repaired aircraft components.

Assembled and tested reservoirs and valve for different type of airplanes.

Assembled and tested hydraulics valves, landing gear and reservoirs for all test gauge.

Set up for test accordance with ATP; analyzed failure and recorded the data.

Followed blue prints from computer and work instructions.

Used hand tools, torque wrenches, open end wrenches, power screw drivers, etc.

Did some electrical work as well using power supplies, oscilloscopes, multimeters, and insulation resistant machine.

Certified soldering training completed.

06/2001-03/2004

Varco System, Orange, CA

Mechanical Assembler/Test Technician

Mechanical and electrical assembly for top drive drilling machine for oil rig equipment.

Set up for test and repair machine to pass inspection.

Used all types of hand tools and power tools for assembly work.

Followed and read blue prints.

Followed schematics for wiring of J boxes.

01/1999-03/2002

Olec Corp., Irvine, CA

Test Tech

Built engineering prototype machine for circuit board from blueprints and schematics.

Perform troubleshooting and repairs.

Education:

John W. North high school: 1980-84: High School Diploma

Riverside City College: 1984-87: Mechanical Engineering

Rancho Santiago College: A&P mechanics

Contact this candidate