Sign in

Electrical Engineering Software

Columbus, Indiana, United States
February 19, 2018

Contact this candidate



336-***-**** ●


Possess extensive educational qualifications with Master's and Bachelor's degrees in Electrical Engineering. Experience in Analysis, Project Coordination and Electrical Design. Familiar with a variety of industry tools including Simulink, MotoHawk for code generation, MotoTune for calibration and CANking for data monitoring and Proficient in Matlab/Simulink/. Exposure to real time projects involving problem-solving through challenges and maximizing skill set through application.



Master of Science, Electrical Engineering DEC 2017

University of New Haven, CT GPA 3.1

Course work: Power Systems, Power Electronics, Electric Drives, Electrical Machines, Embedded Systems

Bachelor of Technology, Electrical Engineering DEC 2015

JNTU, Kakinada,India


Programming Languages: HTML, JAVA, embedded C (basic knowledge)

Technical Tools: Simulink, PSpice, MotoTune, MotoHawk,Hil Systems, CANKing

Hardware Tools : Woodward ECUs, Kvaser CAN


LHP Engineering Solutions At Present

“Fundamentals of Automotive Functional Safety Control Systems using ISO 26262”

SAE Certificate of Mastery Course

Implementing and porting J1939/ISO26262 vehicle applications into a QT environment

Developed CAN based data monitoring and control system

Multi packet frames implementation in CAN protocol

Tested the performance of the controller model on Hardware in Loop (HIL) system by sending CAN messages for data transfer as per J1939 protocol

ECU programming, device calibration with Simulink, MotoHawk and MotoTune for diesel engines

Flashed engine control software and machine control software using MotoTune onto the respective ECMs and validated the functions

Developed model-based engine controls strategy of throttle and fuel injection system using Simulink.Analyzed fault detection for electronic throttle control

Guided the project team in implementation of ISO26262 processes and methods

Implemented low level SW Diagnostics to monitor HW and SW health

Experience in the areas of safety analysis for Systems, Hardware and Software including FMEA, Common Cause Analysis, Dependent Failure Analysis, FTA



Distributed Control System using CAN Communication

Used CANalyzer, CANKing as a part of the test cases for ECU performance

Analyzed and used SAE documentation to decode CAN messages

Tested CANbus by constructing a calibratable CAN message transmitter and used CANKing to monitor bus traffic

Worked on Hardware and software integration

Observed faults detection from hardware using CANalyzer

Design of control strategy for Electronic Throttle Controller

Created Simulink design for system, sensors, actuators and generated code

Developed PI controller with feedback and setpoint for controlling throttle valve

Programmed PI controller and generated source code using MotoHawk

Flashed control software in module through Mototune and calibrated, validate respective functions

Calculated Gain for PI controller using Mototune

Design of a Permanent Magnet Synchronous Generator for Wind Turbine and Battery Energy Storage System

Created energy management algorithm for entire power system

Developed and designed entire power system circuit in Simulink

Designed control strategy in Simulink for DC to DC converter

Examined the results obtained from the simulation

Implemented successfully algorithms for data acquisition

Home Automation by Android Application Based Remote-Control

Designed and developed the project successfully by a team of four members

Analyzed and developed system and software requirements according to specifications

Created and maintained software design, and associated documentation

Used coding practices and created software package

Integrated software in devices and perform unit and integration testing

Developed effective embedded system solutions for existing and new devices

Contact this candidate