Electrical Manager

ROBERT D. GILLESPIE, JR.

*** ******* ****, *********, ** 29689

Phone: 864-***-****; e-mail: *******************@*****.*** OBJECTIVE

To present the skills and qualifications needed to fulfill the position of maintenance electrician EDUCATION Belton-Honea Path High School, Belton, S.C., 1996-2000, High School Diploma EXPERIENCE Journeyman Electrician, IES Industrial

North Carolina, South Carolina, Tennessee and Texas: August 2003-present

Ran various sized conduit, pulled wires, made up and terminated motor leads, motor controls in MCC’s, pushbuttons and VFD’s. Tested wires and cable with various calibrated equipment. Terminated wires. Transformers; distribution, single phase and three phase. MCC’s, switchgear, terminated and tested CAT 5 cable. Stress cones; 3M cold shrink kits and Raychem heat shrink kits. Installed transformers, MCC’s, switchgear and other various electrical panels Lead Maintenance Tech, DZ Atlantic (Oconee Nuclear Station and Catawba) Seneca and Rock Hill, South Carolina: November 2009-November 2017

Implementation of elect-tray for the vital I&C battery cables

Implementation of elect-tray for the Keowee emergency start cables

Terminations and testing of Keowee emergency start cables

Implementation of elect-tray and cables for the security communication project

Implementation of elect-tray and conduit for the ES/RPS

Terminations for the engineered safe guards/reactor protection service

Made sure work was performed to Duke’s standards

Assisted engineering with changes out in the field, such as re-routing tray because of interference not seen on drawings

Assisted with other electrical teams that were behind in the implementation elect-tray on their projects

Provided oversight on all implementation to make sure work was performed in a timely and cost effective manner without compromising quality and craftsmanship

Foreman, PCE

Columbus, Nebraska: April 2009-June 2009

Made sure work was performed up to NEC standards

Had daily meetings with the superintendent and general foreman to plan job schedules

Supervised crew to install MCC’s and electrical panels, distribution transformers, switchgear, various sized cable trays and temporary power

Ran new lighting and receptacle conduits in sub station Foreman, IES Industrial

Anderson, South Carolina: May 2008-April 2009

Made sure work was performed up to NEC standards

Had daily meetings with the superintendent and general foreman to plan job schedules

Performed start up and check out

Supervised crew to pull thermocouple wires to furnace, install PLC cabinets, run various sized conduit from PLC’s to instruments in the field and run conduit to a DC generator at Owens Corning fiberglass facility

I also made and tested all CAT 5 terminations

Helper, IES Industrial

Alabama, Florida, South Carolina: May 2000-August 2003

Ran various sized conduit, pulled wires, made up motor leads, grounding and receptacles

PERSONAL Qualified in various IP procedures with Duke Energy, including: installation of cable trays and concrete anchors, power cable testing, cable terminations, engineering changes to systems and components, exothermic welds, electrical supervisor, and safety tagging

NCCER certified

Blood borne Pathogens training

OSHA 10 training and certification

Arc flash protection and electrical safety training

Training and certification to perform zero energy checks at medium voltage (600v-13,800v) and PLCs through IES Industrial

Certified fiber optics training at Tri-County Technical College and accredited by F.O.A. REFERENCES Tommy Partain, former implementation manager. 864-***-**** Josh Fenten, former supervisor. 864-***-****

Darrin Allen, former coworker. 864-***-****

Contact this candidate