Test Quality Control

Sonny Nguyen

**** * ******* **. *******, CA ***** 657-***-**** ************@*****.***

OBJECTIVE

QA INSPECTOR

SKILLS

Bilingual: English/Vietnamese

Good organizational skills

Works well independently or part of a team

Works well under pressure

Follows directions well

Multitask oriented

EXPERIENCE

Quality Control

Testing filters for Pacesetter Devices and components. Adjusting, and repaired products for processing equipment to correct any defects found during inspections. Using metals, plastics, ceramics, textiles, and other materials. Testing and Inspected hard drive before shipping at (Seagate Storage Cooperation) Inc. Inspected and tested after clean room. Maintain the in process test and final test before shipping. Checking visual inspection under microscope if there is a pinhole and passing an IR test also.

Administered procedural tests to engineers and operators. Inspected before test after clean room. Doing the oven tested before final. Completed metal work pieces to ensure conformance to specifications

Inspection military's parts: Cable and cable connectors. Check soldering before molding. Inspected all parts before shipping. Analyzed and interpreted blueprints, data, manuals, and other materials to determine specifications, inspection and testing procedures, adjustment and certification methods, formulas, and measuring instruments required

Components receiving inspection, checking incoming parts (capacitors, resistors, IC) filing for defective parts. Analyzed test data and made computations as necessary to determine test results. Used microscopes and calibers for dimension

Checked arriving materials to ensure that they match purchase orders and submitted discrepancy reports when problems are found

Discarded or rejected products, materials, and equipment not meeting specifications

Wrote test and inspection reports describing results, recommendations, and needed repairs

Welder/Inspector

Inspected and weld setter light Cells, measured, check the connector healed attach to setter light cell correctly for the aircraft’s parts after clean room

Corrected problems by adjusting controls or by stopping machines and opening holding devices

Gave directions to other workers regarding machine set-up and use

Assembled, aligned, and clamped work pieces into holding fixtures to bond, heat-treat, or solder fabricated metal components

Cleaned, lubricated, maintained, and adjusted equipment to maintain efficient operation, using air hoses, cleaning fluids, and hand tools

Conducted proper trial runs before welding, soldering or brazing and made necessary adjustments to equipment

WORK HISTORY

Scrantom /Aircraft Inc Costa Mesa, California 2010-2016

Spectrolab/Boeing Sylmar, California 2005-2009

Seagate Storage Cooperation Moorpark, California 2001-2005

AVX/Cooperation Sun Valley, California 1998-2000

EDUCATION:

Coastline College – Associate of Arts Degree Fountain Valley, CA 2010

Boeing – Soldering Certification Sylmar, CA 2002

Cleveland High School – Diploma Reseda, CA 1995

Attending-CSUDH Carson, CA 2016

REFERENCES: Available upon request

Contact this candidate