Machine Operator Medical Device

HUNG DIEP

***** *********** **,

San Diego, Ca **126

Phone:619-***-****

Email:*******@*****.***

OBJECTIVE: Seeking an electronic technician position which responsible for

installing, repairing, calibrating, and testing of electronic equipment

EXPERIENCE AND ACCOMPLISHMENTS:

Hewlett Packard 8568B (100HZ –1.5GHZ) Spectrum Analyzer.

Hewlett Packard 85662A Spectrum Analyzer Display

Hewlett Packard 8590A (10 KHZ- 1.5GHZ) Spectrum Analyzer

HP 5351B (500MHZ-26.5GHZ)Microwave Frequency Counter

Hewlett Packard 8642B (100KHZ-2.1GHZ) RF Signal Generator

Leader 3221 RF Signal Generator

Fluke 8311 Multimeter & Oscilloscope

Knowledge of Personal Computer usage with Windows and DOS

software

TESTER I

Dexcom San diego ca 2016

Gen 4 Sensor test. used Software 10401 Version 2.0.0.0 tested Gen 4 Sensor 8 Channels. each brick contain 8 Sensors, the brick went to Soak Trough and 5 Dishes that contain the glucose Solution each brick of 8 Channels Sensor should be tested 3 minutes and temperature 37 degrees.

ELECTRO-MECHANICAL TECHNICIAN

SEMACON BUSINESS MACHINES INC San Diego, CA 2015- 2016

Performed all tasks such as test, modify,installation, dissemble and solder.of Currency Counter and Counterfeit Detector. tested inserted IC chip into the control board. modified Power Supply, removed old part replaced new part used jumper wire connected to capacitor also made and tested connector for motor . using hand tools, stripper, crimper, power and manual screw driver,cutter,pliers and soldering iron.

TESTER & MECHANICAL ASSEMBLER

CAREFUSION San Diego, California 2014-2015

Tested and mechanical assembled LVP of medical device.

Installed and hooked up control board and logic board into LVP component. Tested flashing and alarms using software version, following test procedure of the LVP unit.

ASSEMBLER & MACHINE OPERATOR

ALERE SAN DIEGO MEDICAL DEVICE, INC .

San Diego, California 2013

Essential Performed Assembled, Inspected and Machine Operator Such as 2ND Ink Machine, Solution FETL Machine, Weld Machine, Label Machine and Lid Spray Machine. Complete of The Medical Devices.

ELECTRO-MECHANICAL ASSEMBLER & TEST OPERATOR

CARRIERCOMM, CORP.

Encinitas, California 2011

Set up and perform all test equipment to test Modem, Intermediate

Frequency and Network Interface of Module Products. also Assemble,

Disassemble,Install and Rework.

REPAIR TECHNICIAN

STANDARD COMMUNICATIONCorp.Satellite & Broadband,

Product Division, Torrance California 2004 – 2009

Set up and operate all test equipment to tune, adjust and repair up-

down RF Converter of Satellite Network Television Modulator System

on both stock and customer repair. Ability to troubleshoot problems to

the component level. Ability to read schematics component drawing

Experience on troubleshooting surface mounted components on

printed circuit assembly boards

Knowledge and use of, Signal Generator, Oscilloscope, Voltmeter

and Spectrum Analyzer.

REPAIR TECNICIAN

MAGNETEK, INC. Chatsworth, California 1994 – 2003

Troubleshot AC-DC, DC-DC Switching circuits of power supplies

with multiple out put. Perform production testing, set up test equipment

troubleshoot to component level

Repair control circuit boards which control the outputs on both stock

and customer repairs

EDUCATION: National Technical School, Los Angeles, California 1981-1982

Associate in Science Degree

Major: Electronic technology

Associated Technology College, Los Angeles California 1992-1993

Diploma in Telecommunications

Contact this candidate