Sameer Nepal

*** ******* *** *** * Sunnyvale, CA 94086 408-***-****

ac1j48@r.postjobfree.com

OBJECTIVE

Looking for open positions in the field of Electrical Engineering. EDUCATION

SAN JOSE STATE UNIVERSITY May 2017

• Bachelor of Science in Electrical Engineering.

• Courses taken: Circuit and System, Signal Processing, Digital Logic Design, Microprocessor System Design, Electronics Design, Analog Peripheral for Embedded Systems, Power Electronics, Control System.

• GPA: 3.44

DE ANZA COLLEGE 2013 - 2015

• Basic courses relevant to Transfer to University WORK EXPERIENCE

UBER (October 15, 2015 – now)

Customer Service (Part time: 30 hours/week)

• Driving and helping the customers with their luggage WHOLE FOODS MARKET (March 15, 2014 – April 10, 2016) Customer Service Representative (Part time: 25 hours/week)

• Helping customers with shopping and making the bills. QUALIFIED SKILLS

Engineering skills:

• Use of LTspice to design the electrical circuits

• Using Diptrace to design the PCB layout

• Soldering electrical components to develop the PCB board

• Experienced in C, C++, assembly programming.

• Electronic circuits including switch-mode regulators, AC-DC, DC-DC and DC-AC conversion.

• Experience in logic gates, FPGA board, Op-Amp, Transistors Analysis, Integrated circuit amplifier, Feedback Amplifier.

• Programming the microcontroller to achieve the result (SAM D20, MSP Launchpad)

• Good knowledge on Microsoft Words and Excel.

• Very familiar with the lab equipment (oscilloscope, power supply) Projects:

Senior Project Design: Wireless Power Transfer with resonant coupling method

• Worked in a group to develop the wireless charging system.

• The system consists of power conversion AC-DC, DC-AC, transmitter coil, receiver coil.

• Responsible for the design of the coil and simulation of the circuit in LTspice.

• Helped in the development of the PCB board design.

• Responsible for soldering the components in the PCB board and testing the circuit. Design of Charger using solar:

• With the help of energy harvesting circuit, the prototype to charge the cell phone was designed.

• It was the project for the course Circuit Design

• Used LTspice to design the circuit and simulate it and Diptrace to design the PCB board.

• Soldered the necessary elements into the board

Pinball with PicoBlaze using Xilinx Artix 7 FPGA:

• Game was designed using the PicoBlaze and different control systems.

• Responsible for using Vivado Design Suite for the design of the game structure.

• Design of the layout of the game.