Sign in

Embedded engineer

Pune, Maharashtra, India
June 01, 2017

Contact this candidate


Somesh Varpe

Embedded Engineer - Minilec India Pvt Ltd

Pune, Maharashtra - 895-***-****


Embedded Engineer

Minilec India Pvt Ltd - Pune, Maharashtra - February 2015 to Present Roles and Responsibility:-

• Developing and Testing Micro-controller product using 8052 and PIC16f controller.

• Preparation of Handover documents of Product.

• Making changes in the hardware as well software as per customer requirement.

• Testing and finalise Modbus protocol using in Alarm Annunciator with the help of RS-485 standard.

• Using different cards in Annunciator like Supply Failed and Repeat Relay card to test and final. Project handled:-

"Alarm Annunciator to indicating faults through COCKPIT SYSTEM" The annunciator is using to inform the customer to present which fault is coming in system.when their is some problem in our system is indicated faults and it is easily get to understand and the solve problems in system. We are using different module in Annunciator to connected other devices. RS-485 Communication Card:- This communication card is using in alarm annunciator to communicate PLC, SCADA and etc devices with help of Modbus protocol. Repeat Relay Card:- This card is using to connect the hooter, buzzer and other peripheral for each fault and it is very helpful to understand the problems.

Supply Fail Card:- Supply fail relay is advance feature of Alarm annunciator, which allows the unit to run on backup power supply in case of main supply fails. It fully hardware card and featured with supply fail indicator. EDUCATION

Bachelor of Engineering in Electronics & Communication in Course of Embedded System Design

VTU University

August 2014


derivatives (Less than 1 year), Embedded C programming (Less than 1 year), I2C (Less than 1 year), PCB

(Less than 1 year), PCB Design (Less than 1 year)


Technical Skills:-

• 8 & 16 bit micro-controller based system design and development.

• Embedded C programming for 8051 and PIC micro-controllers.

• Designing and construct OP-AMP and SMPS.

• Knowledge about Modbus, I2C, SPI, UART protocols. Tools:-

• IDE: Keil, MPLAB, MPLAB X, Turbo C.

• PCB Design: Altium Design, Express PCB editor.

• Circuit simulation: Proteus 8, Multisim.

• Micro-controller: 8051 derivatives, PIC 16f.

Contact this candidate