Post Job Free
Sign in

Customer Service Electrical

Location:
Independence, IA, 50644
Posted:
December 27, 2010

Contact this candidate

Resume:

JOHN F. NENNIG *** *th Ave. SW Independence, Iowa 50644

319-***-**** *******@*******.***

Electrical

Wired outlets for welders for a balanced load on a 3 phase y

Troubleshot electric stoves and refrigerators

Checked ac squirrel cage motors for shorted coils.

Checked ac single phase motor starting switch for continuity

Checked and replaced capacitors on capacitor start motors

Wired transformers to buck or boost voltages or increase amperage capacity

Bent and installed emt conduit

Planned and installed wiring, outlets, switches and light fixtures.

Ordered materials and installed service entrances

Planned and wired outlets for air conditioners, stoves, and dryers.

Connected computers on a TCP/IP ethernet bus circuit using ATT crossconnects and Cisco Hubs

Installed phone circuit extensions

Installed and terminated coax cable for TV service drops

Wired thermostat and airconditioner circuits to the furnace

Pulled wire and leveled, mounted and connected thermostats

Mounted electrical disconnect and connected it to electrical panel and to the air conditioner.

Troubleshot and repaired Fire Alarm systems

Troubleshot and repaired emergency, exit and combo lights

Installed G.F.C.I. outlets to protect others on the circuit.

Plumbing

Installed water (hard and soft copper) by sweating soldering, flare connections & compr. fittings.

Installed sewer using PVC

Threaded galvanized and black pipe

Installed water closets, vanities, shower stalls, tubs, sinks, garbage disposals according to code

Installed waterclosets to flange with beeswax seal.

Replaced hotwater heaters (gas and electric) and tested the system for gas leaks.

Cleaned drains with a roto rooter

Installed soilstacks according to code

Installed dishwashers and washers

Installed sewer cleanouts

Sealed joints with oakum and sinthered lead

Installed sump pumps

Mechanical

Installed & troubleshot garage doors openers

Installed and adjusted the up and down limit switches on garage door openers.

Troubleshot air compressors and air distribution systems

Repaired electric stoves, dishwashers, washers and dryers

Troubleshot Tokheim, Gasboy, Filrite, Bennett, Wayne, Red Jacket and Gilbarco gas pumps

JOHN F. NENNIG 203 9th Ave. SW Independence, Iowa 50644

319-***-**** *******@*******.***

Carpentry

Installed door, window units and their trim

Installed decking & roofing (rolled roofing as well as Shingles)

Safely used drill presses, coredrills, tablesaws, skillsaws, jigsaws, chainsaws, routers, jointers, surfacers.

Cut holes in masonary walls with coredrills, stardrills and masonary bits

Weatherstripped doors

Safely used sawzall, angle drill, rotohammer, rotozip tool, skill saw and holehog.

Insulated walls and ceilings

Designed and built decks

Built stud walls with door and window openings

Blown insulation into attics

HVAC

Safely assembled 14x8 square duct

Interpret a floorplan and identify locations for hot air and return air boots.

Safely cut the underlayment without cutting into floor joists, low joists,or I beam top flanges

Assemble 5 foot 6”,7”,8” pipe so that the seam is oriented up and parallel to the sides of the pipe.

Placed and leveled air-conditioner pads

Located, and cut boot holes

Installed angle, straight, and end boots.

Connected boots with hot air trunk with 5,6,7,or 8 inch pipe.

Installed 6 and 7 inch oval pipe to feed second floor.

Used thermopan / stapler to end cap and pan cold air returns.

Adjusted elbows for offsets and angular applications.

Installed 1, , and inch black pipe with valves and unions to supply gas to appliances.

Relite waterheaters.

Installed drain on furnace and A coil.

Cut and treaded 1, , black pipe

Maintained inventory on the service truck.

Recorded parts of the job still unfinshed and a list of materials still needed.

Mounted hot air registers.

Installed 6,7, and 8 inch collars in heat trunks.

Uncoiled and strapped line sets.

Ran, tie wrapped and strapped insulated flexduct.

Ran and taped dryer vent

Ran and glued pvc furnace intake and exhaust

E XPERIENCE

Per Mar Security, Technician

Waterloo Fire Extinguisher, Fire Alarm Tech

Technisource (Rockwell Collins), Cedar Rapids, IA Network Tech

Selectivend, Waukee, IA Technical Customer Service Vending Machine Manufacturer

Petroleum Equipment and Service, Marion, IA Gas pump technician

Western Dubuque Schools, Farley IA Industrial Arts Instructor

Habitat for Humanity



Contact this candidate