Quality Control Manager

**** **** ****** 916-***-**** Sacramento, Ca *****

***********@*****.***

Eric French

Objective I am qualified for mechanical and electronics manufacturing, quality, test or troubleshooting positions and am

looking for a progressive company where I would be able to expand my potential and enhance my career path.

Professional

Experience 11/1/09 – 1/15/11 Teledyne MEC Rancho Cordova, CA

Quality Control Inspector III

•Performed complex receiving lot inspections by AQL and 100% for in-coming material for

advanced radar jamming equipment under AS and Mil-Spec guidelines.

•Facilitated the Material Review Board for Quality, Production and Engineering Departments,

providing analysis on the critical nature of the nonconformance.

•Documented and logged all non-conforming material in databases and compiled data for

flowcharts and pareto charts.

•Performed 100 %lot inspections on production fixtures that are on recall intervals.

11/17/08 - 4/8/09 Paragon Products El Dorado Hills, CA

Quality Control Inspector Lead

•Performed in-process inspections for fuel pump assemblies

•Facilitated the Material Review Board for Quality, Production and Logistics Departments.

•Submitted daily and weekly paretos for management review.

•Documented and logged all non-conforming material.

•Performed %100 lot inspections on raw material, sub-assemblies, machined parts and electronic

circuits for fuel pumps for the railroad industry.

11/15/05 - 6/31/08 Volcano Corporation Rancho Cordova, Ca

Quality Control Inspector Lead

•Preformed lot inspections and first article inspections on incoming raw material, parts and

subassemblies for various coronary catheter and coronary catheter related product line to

ISO 13485: 2003, FDA and GMP standards.

•Consulted with Research and Development engineers on design modifications and discrepancy

correction.

•Consulted with Production Engineers and Managers on resolving MRB issues.

•Performed measurements using Geometric Dimensioning and Tolerance methods.

•Worked with quality and production engineering staff to resolve issues that arise during

inspections due to insufficient or outdated inspection requirements and procedures.

•Contacted suppliers to resolve material certification and part discrepancies.

•Assisted and trained other inspectors on measurement and inspection techniques and

procedures.

•Ordered test or measurement equipment and ensured current equipment was calibrated and met

readability and repeatability standards.

7/5/03 - 5/20/05 Northern California Injection Molding Rancho Cordova, Ca

Quality Supervisor

•Performed first article inspections on CMM.

•Measured products to customer specs and tolerances using calipers, micrometers and depth

micrometers.

•Oversaw material handling to ensure proper material and material lot numbers were being used.

•Supervised and trained employees.

11/1/99 - 5/1/03 REMEC Veriteck Escondido, Ca

QC Test Technician

•Tested PC boards to ISO 9002 standards.

•Maintain and calibrate test fixtures such as ICT Genrad and custom static test fixtures provided

by the customers.

•Troubleshot boards down to component level and wrote instructions for rework to be performed.

•Trained and instructed testers on ISO procedures.

•Consulted with Production Supervisors and Production Manager on efficient methods to increase

test acceptance yields

Education 1/94 -9/99 California State University San Marcos San Marcos, Ca

Computer Information Systems

•Received AS in CIS

•Currently preparing for CQT with ASQ.

References available upon request

Contact this candidate