Mzee Young
Security Officer
Seagoville, TX
*********@*****.*** - 972-***-****
WORK EXPERIENCE
Security Officer
Allied Barton - November 2011 to January 2013
Respond on an on-call basis to the field to provide protection for clients.
• Man post as instructed and serve as a general security presence and visible deterrent to crime and client
rule infractions
• Detect suspicious activities and watch for criminal acts or client rule infractions at or near assigned post which
may be a threat to the property, client or employees at the site
• Report all incidents, accidents or medical emergencies
• Respond to emergencies, such as medical, bomb threats, severe weather, and to alarms such as fire and
intrusion by following emergency response procedures.
Electronics Technician
Regal Staffing - June 2011 to August 2011
Performed upgrades, tested, troubleshooting and repair of electronic equipment.
• Performed direct and general support (DS/GS) level maintenance of radio receivers and transmitters
• Maintains commercial-off-the shelf (COTS) and special purpose computers
• Uses test, measurement and diagnostic equipment to determine the cause and location of malfunctions,
extent of faults and category of maintenance required
• Repairs systems, equipment and subassemblies by adjusting, aligning, repairing and replacing defective
components
MIG Welder
Metal Fabricator - July 2004 to June 2011
Responsible for the set-up, lay-out, and tack-up of various precision frame weldments and brackets.
• Welds metal parts together, using both gas welding or brazing and any combination of arc welding processes
• Fabricated metal products preparatory to welding
• Responsibilities include welding equipment, fabricating, fitting, sheet metal installation, vehicle body work to
meet specifications and required standards
• Determine project requirements, including scope, assembly sequences, and required methods and materials,
according to blueprints, drawings, and written or verbal instructions.
• Layout, measure, and mark dimensions and reference lines according to drawings and templates, using
calculators, scribes, dividers, squares, and rulers.
• Select gauges and types of sheet metal according to product specifications.
• Drill, Tap, and punch holes in metal, for screws, bolts, and rivets.
• Fasten seams and joints together with welds, bolts, rivets, solder, to assemble components into products
or to repair sheet metal items.
• Fabricate or alter parts as needed, using press brake, shears, saws, hammers, punches, and drills.
Temporary employee
Aerotek - December 2003 to July 2004
Completed various temporary assignments such as warehousing/general labor activities through Aerotek until
hired permanently by Altec Industries in 2004.
Machinist/Aviation Mate
US Navy - July 2000 to September 2003
As an Aviation Machinist Mate (AD) was able to work in/around jet power plants and related systems, and
perform mechanic work at fleet and shore activities.
• As a Machinist Mate (MM) performed routine maintenance procedures on the components of the Aircraft
Carrier (CV-67), such as naval boilers, evaporators, distillers, centrifugal pumps, steam turbines, reduction
gears, propellers and shafting, shipboard electric systems, and internal combustion engines (including gas
turbines)
• Maintaining and servicing aircraft engine, fuel and lubrication systems
• Handling and servicing aircraft ashore or aboard ship
• Performing complete aircraft turbo shaft/turboprop engine repair
• Determining reasons for engine degradation via spectrometric oil analysis tests
• Evaluating jet engine performance, using jet test cells for fixed turbojet engines
• Performing helicopter maintenance, installing and maintaining engines, drive accessories and gear boxes
and propeller repairs
EDUCATION
Associate of Science in Computer Electronics and Telecommunications Technology
Herzing University - Birmingham, AL
August 2010