GUANGLEI AN

*** * ****** **, *** **, Stillwater, Ok, 74075

205-***-**** (m)

ab34nz@r.postjobfree.com

OBJECTIVE

Actively seeking for a Full-Time position in Analog, Mixed Signal IC circuit Design Position

SUMMARY

Three plus years of experience in design and development of low power low voltage analog/mixed signal circuits

in CMOS submicron processes

Good knowledge of Operational amplifier, low noise low voltage amplifier, Comparators, Switched-capacitor

circuits, Pipelined Analog to Digital Converter (ADC). Good understanding of frequency domain analysis and

noise power trade off

Familiar with custom design, simulation, layout and testing with Spectre and Hspice Cadence tool. Solid

background of behavior simulation of Verilog and Verilog-AMS for circuit design.

Good communication skills and ability to work collaboratively in team

EDUCATION

PhD, Analog/Mixed-signal Design, Oklahoma State University, 2008 – Present

MS, Electronics Engineering, ChongQing University of Post and Telecommunication, 2004 – 2007

BS, Communication Engineering, JiLin University, 2000 – 2004

PROJECT

Designed and implemented low noise, low power two stage neural amplifiers for implantable active Radio-

Frequency Identification Sensors

o Power, area and gain optimization greatly improved the power efficiency

o High gain, low noise, low distortion and adjustable 3dB frequency realized by feedback capacitor and

current biased Pseudo resistor is achieved

o The designed bandpass amplifier consumes ultra-low power and is applied for real animal neural signal

testing

Developed low power Pipelined ADC for neural recording applications using IBM 180nm process

o Analyzed top level behavior of the system by Verilog-A model and determined the design specification

parameters in each stage

o Designed two stage folded cascaded Opamp with indirect compensation, comparators, ADC and DAC

structures, basic digital circuits

EXPERIENCE

Proficient in transistor level design of analog circuits

Proficient in design, simulation, layout, and testing experience using Cadence tools, Spectre and Hspice

o Familiar with schematic entry, full custom layout, DRC, LVS, using Virtuoso and Assura

Skilled in handling testing equipment like probe station, oscilloscope, Logic analyzer and spectrum analyzer for

Wafer measurements

Proficient in design, schematic, and layout of PCBs using Altium and Visio tools

Contact this candidate