Machinist Inspector CMM Operator

Job Description

Work from approved inspection plans, engineering drawings, purchase orders, operation sheets and specifications. Use a variety of precision measuring instruments to verify compliance on dimensions, angles, radii, contours, holes, surface finishes, concentricity, hardness, material and plating.

Inspect incoming hardware utilizing CMM Cad Models/inspection plans.

Checks parts visually for burrs, finish, and any related defects that would be cause for the rejection of parts

Use a wide variety of precision measuring instruments to verify compliance on: dimensions, angles, radii, contours, holes, surface finish, concentricity, hardness, plating, etc.

Should be proficient with sine plate, comparators, profile-meter and surface plate layout using height gauges.

Work involves simple to complex setups on surface plates using height gauge, gauge blocks, sine plates and indicators.

Maintain daily logs and initiate non-conforming documentation for parts not meeting requirements.

Required Skills:

Generating RMA, NCR, and CAR

Minimum 3-5 years’ experience with the inspection of aircraft components.

Must be able to inspect all of the above mentioned dimensions.

C.M.M. experience required.

Competence to read and interpret documents such as safety policies, operating and maintenance instructions, and procedure manuals.

Ability to write routine reports and correspondence.

Ability to effectively speak after individuals and groups of employees within the organization.

Ability to add, subtract, multiply, and divide in units of measure, using whole numbers, common fractions, and decimals.

Ability to apply common sense understanding to carry out simple one or two step instructions.

Basic knowledge of AS9100 requirements.

May have to perform calibration on gauges needed for production.

Utilizes shop math in all dimensional checking as well as precision measuring devices.

Experience interpreting & inspecting GD&T features (preferred).

Experience working in an aerospace company.

Experience working with a CMM.

Follows inspection procedure for each inspection.

Follows all procedures such as signing off each step on the router.

Keeping up with calibration log and calibrating employees’ and CIM inspection equipment.

High knowledge of inspection equipment (Caliper, Micrometer, Height gauge, Optical Comparator and CMM).

Demonstrated expertise in Geometric Dimensioning and Tolerance (GD&T).

Proficient in operating CMMs.

Solid technical knowledge and hands-on experience with measurement tools and equipment.

We are an Equal Employment Opportunity Employer.Company Description

J&M Products has over 50 years of manufacturing experience and is one of the leaders in line support clamps and wire harnesses. They are dedicated to the design, development, manufacture and marketing of high quality products and services. J&M Products are selected by major aerospace, transportation and industrial equipment manufactures.

Full-time