Slitter Machine Operator

A metal service center is seeking a Slitter Machine Operator to work Monday through Friday from 7 a.m. to 3:30 p.m.

Job Duties:

Prior to starting machine every morning, ensure all safety mechanisms are functioning properly

Transport material to entry section, check coil according to work card, attach label with width, thickness, and coil ID and if necessary change ID

Calculate and setup arbor according to work card

Setup over arm spacer rolls according to setup

Set coil on uncoiler and expand mandrel

Open Coil and feed strip to side guide rolls

Lock knife arbor, feed strip in arbor, set de-burring rolls, and cut off any rust or defects

Check width and thickness according to work order, if necessary check camber, crossbow, hardness and document on quality sheets

Prepare tension stand with felts, tie scrap, feed strip through tension stand, and check constantly strip surface visually

Perform visual quality check of strip surface, close tension stand, and check pressure

Change mode to operation, run coil until brake or in full, check constantly strip surface, and report quality issues to supervisor

Perform other duties as needed