Injection Molding Process Technician

We are hiring an Injection Molding Process Technician for our RESRG Automotive facility in Covington, GA. With a global footprint across four continents and a commitment to sustainability, RESRG Automotive specializes in advanced exterior and interior systems, offering cutting-edge technologies to meet the evolving demands of the automotive industry.

The schedule is for 2nd shift: Monday through Friday, 2PM to 11PM.

A Day In The Life Typically Includes

Responsible for following all plant safety policies

Responsible for following all plant ISO / TS 16949 & ISO-14001 policies and instructions

Setting up hot runner controllers, valve gate units and injection press and auxiliary equipment

Releasing good parts at start-up

Troubleshooting and correcting all aspects of the process to make quality molded parts

Support engineering on tool trials and scrap reduction

Maintaining a clean and organized work area

Maintaining daily run sheets

Reading and understanding documentation to install tools, hot runners and valve gate units

Reading and understanding documentation to support engineering in support scrap reduction

What You Will Need?

1-3 years of injection molding experience

Experience using hand tools

Experience using measurement tools (calipers, micrometers, etc.)

Experience using a computer, tablet or smartphone

High school diploma or GED

Minimum of three (3) years of experience as a Process Technician or similar role

Experience with Injection Molding

Physical Demands

The physical demands described here are representative of those an employee encounters while performing the essential functions of this job. While performing this job the employee will be:

Standing, Walking, Bending, Lifting, Laying, using Stairs/ladders to perform work, climbing

Maximum lifting will be 50 pounds

Work will be on concrete floors and at elevated levels if needed to perform work on mold presses

Work Environment

The Process Technician will be required to wear hearing protection, eye protection and safety shoes

The facility is temperature controlled; the normal temperature is approximately 68F during the winter and 85F during the summer

Daily work involves working with grease, oils and other manufacturing related chemicals

Daily work involves being in and around elevated temperatures and heat sources of up to 800F

This is an hourly role and reports to the Process Supervisor.