Assembler Advanced (Franklin WI) Job Summary In this job you will perform a variety of assembly and test positions for IntelliRupter and Power Quality products.
You will work in a production environment, engage in continuous productive activity, and must meet requirements within time constraints.
Considerable initiative required to run and process all IntilliRupter units through test and assembly cells, a fast paced multi station process.
Tasks require a high degree of eye-hand coordination, manual dexterity, and the use of both hands and arms on a repetitive basis for a full range of motion.
You will frequently use hand and power tools; occasionally work while standing on ladders; and occasionally work inside tight compartments.
The responsibilities of this position include, but are not limited to, the following: * Assemble and test IntelliRupter products based on the documentation including bills of material, blueprints and any change notices provided by the engineering staff.
* Complete testing at timing stations and run switch through 4 operations station.
* Complete mechanical work including disconnect assemblies.
* Experience troubleshooting electrical issues You will be performing the following tests: * Timing Test capacitor voltage 425 DC * Partial Discharge Test AC voltage 50KV * Dielectric test 3 phase AC voltage 60KV-70KV * Calibration test parallel AC voltage 8.7KV-18KV in series 600 amps.
* 3 phase AC high voltage 8.7KV -18KV with 20 amps - 45 amps.
* Low voltage test capacitor voltage 425 DC To select this job as one of interest to you, at a minimum, you must have the following: * High voltage electrical experience is required to run the required test cells.
5KV / 3phase * Demonstrate the ability to work from complex blueprints, wiring drawings, schematic diagrams, and specifications.
* Demonstrate knowledge and experience to troubleshoot mechanical or electrical issues.
* Demonstrate experience using and operating machining tools, hand-held tools, wiring equipment, wrenches, torque tools, and other tools.
* Must follow all S&C safety standards.
* Relevant Work Experience: Two years of experience in electronic assembly and wiring with 5KV * 2 year technical degree preferred.
* Candidates with electrical or mechanical trade school education may also be considered in lieu of experience MAJOR PHYSICAL DEMANDS * Standing: Most tasks are performed in a standing position with intermittent walking.
* Lifting: Frequent lifting of items ranging in weight from 5 lbs.
to 40 lbs.
* Walking: Frequent walking of short distances to obtain parts for assembly.
* Carrying: Occasional carrying of items ranging in weight from 5 lbs.
to 25 lbs.
* Pushing: Occasional pushing of handcart to/from assembly area containing up to 50 lbs.
* Pulling: Occasional pulling of handcart to/from assembly area containing up to 50 lbs.
* Bending: Frequent bending and crouching required to complete the assembly/wiring tasks.
* Reaching: Continuous full range of motion from above the shoulders to below the knees.
* Handling: Continuous handling of parts (all sizes) along with a variety of hand tools.