control panel wireman

Luis A. Alonso

***** ****** **.

Houston, TX 77072

832-***-****(cell)

*****************@*****.***

Experience

Control Panel Wireman, Pentair Thermal Management

July 2011 – Present

• Comprehend schematics/blueprints for new enclosure to wire from scratch.

• Responsible for obtaining material needed to start new enclosure project such as getting

measurements and cutting wire that I would be using to wire enclosure. Some other

materials I was responsible was pulling out fuses, transformers, contactors, breakers,

relays and CPU that was necessary to wire according to schematics/blueprints.

• When routing wire on back pan or side pan I was responsible to route neatly and tag all

wires for future reference and because of course the enclosures where for customers.

• Some other duties were to retrofit/modify back panels that were being wired that

sometimes would not fit inside enclosures because of enclosure manufactures would

slightly be off with measurements of bolts and back pan or side pan would match bolts.

• Sometimes there were measurements off a bit coming in from assembly so I had to

modify back pan or Panduit was small for wire to be routed in I had to replace Panduit

with a larger one.

Electrical Apprentice, Moeller Electric

August 2010-July 2011

• Residential, Commercial and Industrial electrical wiring

• Residential: Comprehend Blue Prints of House. Assemble electrical panel and install

electrical service for house (120/240Volts). Route Romex throughout the house for

installing of electrical outlets, switches, fans and light fixtures.

• Commercial: Comprehend Blue Prints of building. Assemble electrical panel and install

electrical service for building (240/480Volts). Route(mount) ”-3” EMT throughout

building for running of wire and future installation of electrical outlets, switches, fans

and light fixtures.

• Industrial: Assemble (480Volts) electrical panel to be installed in places such as lift

stations, waste plants and water plants. Mount 1”-3” rigid pipe for wire runs. Place

transformer for the reducing of voltage, now the able to run power to your (120/240Volts)

outlets, switches, fans and light fixtures.

Shipping/Receiving, Behl Precision

August 2008 –August 2010

• Assemble products and then stamp with part number for future reference.

• Wrap and package finished fabrication in boxes or carefully place on pallets for delivery

to customers in Houston and surrounding areas.

• Load pallets onto company box truck/ van using sit down forklift so I could deliver

packages.

• Unload materials from freight line when delivered to our company.

Shipping/Receiving, APC Houston

May 2007- August 2008

• Pull orders for customers off of shelves using stand up forklift.

• Maintain and restock inventory of flanges.

• Set product on pallet and shrink wrap for safe delivery.

Education

Lee High School, Houston, TX

August 2003 – May 2007

University of St. Thomas, Houston, TX

August 2007 – August 2008

Houston Community College, Houston, TX

August 2012 – Present

Contact this candidate