Sign in

Manufacturing Support Worker - 165542

Clover, South Carolina, 29710, United States
September 16, 2017


• Removes porcelain forms from carriers and pin forms on dip racks per a standardized pattern.

• Route carriers to Roll Room ensuring maximum bead rolling production.

• Removes excess rubber cement from racks after forms are removed at the Roll Room.

• Using pressure washer, clean racks of forms before sending to the Masterloop Operator.


• This is a team job with the ability to remove and pin all short form racks allowing the Stripper/Turner to strip/turn racks at the rate of one rack every 18 minutes, and likewise for all glove box racks.

• These pinned racks must be properly balanced with the rack in the correct rack and form location.

• Included is pressure washing all racks of forms to minimize dirty forms that must be sent to Form Maintenance for cleaning.

• Also, excess rubber must be scrapped from the racks after rolling along with providing carriers to the rollers.



• Basic reading/writing and math skills for following procedures and reporting production.

• High School diploma or GED.

• Maintains good safety and attendance record in accordance to Plant policies.

• Performs all job duties in conjunction with Plant established quality system.


• Basic computer skills in order to assist as needed in operating the Autoclave monitor.

• Rubber Glove manufacturing experience.

• Lean Manufacturing experience.

• ISO9000 experience.


• Remove forms from carriers after stripping and pin forms on properly balanced racks.

• Wash and pressure wash all forms.

• Removes excess rubber scrap from racks to ensure quality standards are met.

• Remove sub-standard forms or carriers from system.

• Tighten loose clips as found.

• Provide proper size carriers to Roll Room as needed.

• Using the Dip Rack Card Board, set and pin forms as needed per scheduled dip card.

• Operates at all times in accordance with Plant safety policies and quality system.

• Practices good housekeeping duties in work area.

• Reports all faulty or unsafe conditions to supervision.

• Performs other job related duties as directed by shift supervision.

• Commits to and participates in plant 5 S and continual improvement activities.


• Providing continuous production flow from Stripping/Turning to the Dip Room by performing duties of job without any delays.

• Also, providing carriers to the Rollers to prevent production delays.

• Following the dip card schedule to provide the correct balanced rack and forms to be dipped.

NOTE: Candidate must be US Citizen or Green Card Holder or Permanent Resident.