THOMAS S. LLYOD

*** ****** ****

Haverhill, MA **830

Telephone: 978-***-****

OBJECTIVE: To obtain a challenging position where I can apply my skills as an Electrical/Mechanical technician.

SUMMARY OF QUALIFICATIONS:

Wrote technical procedures and documented assembly of machines at the department level.

Possess a thorough understanding of vacuum-system theory. Knowledgeable in assembly procedures and practices.

Certified in the use of Varian leak-detectors. Experienced in working with control systems (VME architecture). Complete comprehension of electrical schematics, with a functional understanding of power distribution and electrical components. Possess a strong understanding of robotics and robot controls, including motor encoders, and speed controls. Effective communicator both within and outside of the organization.

EXPERIENCE:

CURRENT: Hospice Care for mother

04/2007-10/2007 Crane Aerospace: Electro-Mechanical Build Technician

Responsible for the build, test, and quality control inspection of 1405 communication / radar systems and chassis for Blackhawk and Fl8 fighter jets.

Experience with installation of fiber optics and microwave equipment for the military. Experienced with x-ray weld, shock test, and heat test of devices.

6/2003 – 2/2005 BROOKS AUTOMATION: Chelmsford, MA: Electro – Mechanical Technician

Responsible for the precision electro - mechanical build and qualification of robotic arms used in wafer systems.

Extensive experience in reading and interpreting system prints and schematics.

Responsible for testing finished products (dip / repeatability testing).

9/2002-3/2003 TMC CORPORATION: Peabody, MA Electro - Mechanical Build Technician (Contract position)

Mechanical and electrical assembly of stacis table systems. System test and programming of systems using oscilloscopes and analyzers.

Programmed controllers and software. Completed point-to-point wiring and made harnesses for chassis.

Proficient in the use of multi-meters, soldering guns, and various hand tools.

1999 - 2002 TOKYO ELECTRON: Beverly, MA Electro - Mechanical Technician

Responsible for mechanical and electrical assembly of etchers from blueprints and operations sheets.

Performed leak-check and tested machines while under vacuum.

Tested systems (robotics / vacuum) utilizing multi/volt meters to insure product was within specs for wafer programming.

Programmed Yasakawa robots to run wafer programs.

Technical writing of operation sheets (assembly procedures, spec sheet reports, test data sheets) using excel and various Microsoft programs.

1998 - 1999 ANALOGIC INC.: Peabody, MA Electro - Mechanical Assembler

Wrote and maintained reports and procedures to instruct workers in proper standards of assembly of product.Responsible for performing mechanical and electro -mechanical build of assemblies/sub-assemblies. Reported directly to Department Manager.

1997 - 1998 EATON SEMICONDUCTOR Beverley, MA Electro – Mechanical Technician

Responsible for assembly of mechanical electrical subassemblies, service modules, terminals, and cell controllers. point to point wiring of controllers.

Worked from schematics / blueprints, tested assemblies, and quality control final product.

1995 - 1997 TEK TRON ENGINEERING: Topsfield, MA Electro – Mechanical Technician

Completed the electro mechanical build and testing of chassis and industrial control panels.

Performed point-to-point wiring of panels, chassis, and cable harnesses.

Performed RF / Microwave prototype assembly and testing.

Performed in-process QC inspection on all work.

1980 - 1994 AT & T: North Andover, MA: Q.C. Audit Inspector/ Layout

Completed the electro – mechanical inspection of Naval equipment, including bays / telecom / T1 repeater systems, and transmission equipment utilized in destroyers.

Experienced in the use of high-powered microscopes.

Independently instructed a course in visual diagnostics utilizing microscopes.

Managed a department 18 employees daily, reporting to the department chief.

REFERENCES: Available upon Request.

Contact this candidate