Manual Machinist Master Control

Dennis M. McLaughlin

***** *** ******

Madison,Alabama 35756

573-***-****

ado3ec@r.postjobfree.com

QUAlifications

Master Machinist

Microsoft Office, Word, Power Point

Federal Environmental Laws

Environmental Auditing

Recycling, Reusing, Reducing

Risk Management

Presentations

Alternative Thinking

Training Others in Safety

Work Experience & Achievements

Detroit Tool Metal Products, Lebanon, Missouri

Shear Operator:

• Set-up and Operate a CNC Shear and a Rolling Shear

• Sheared High Vis Aluminum, Stainless Steel and Steel

• Material Handler, Fork Lift Driver

• Operated Turret Presses, Lasers, Spot Welder, Break press and Heavy Presses

Modine Manufacturing, Camdenton, Missouri

Fabricator:

• Set-up Production Equipment, to produce quality Air Coolers, Oil Coolers, and Radiators

• Preventative Maintenance on all Production Equipment, Recorded Daily and Weekly

• New employee and Transfer employee Orientation on safety and production procedures, also employees from other Modine Plants

• CNC Mill: Set-up and alterations for tolerances and efficiency

• Worked closely with Engineers in the Research and Development of new Products, from test runs to production

• Quality Control: Recorded First Article Inspections and Hourly Inspections, with precision instruments,

• Set-up: Heavy Presses, Light Presses, Turret Presses and Break Press, Saws, Shear, Mills, Bench Presses and Forklift Operator

Trico Manufacturing Inc., Richland, Missouri

Machinist, Supervisor:

• Produced High Quality Aircraft Parts for Boeing, General Dynamics,

British Aero and Mac Donnell Douglas

• Maintained and Repaired, the Equipment, the Grounds, and the Building

• Administered and Instructed all Safety and Technical Procedures Throughout the Plant

• Organized, Delegated, and Supervised the day to day operations

• Managed employees to High Quality standards and Lean Manufacturing

• Acquisitions and Procurement of Materials and Tools

• Initiated a Recycling Program

• Repaired and Built, Dies and Fixtures

• Manual Machinist and CNC Machinist: CNC Turning Center and CNC Mills, Water Jet

• Worked Closely with Aero Space Engineers and Federal Inspectors to be Certified and Compliant with Government Regulations

Education

• Master of Science in Environmental Management

Webster University, St. Louis, Missouri

• Bachelor of Science in Business Administration

Columbia College, Columbia, Missouri

Certifications

• Emergency Management Institute,

FEMA, IS-00454,

Fundamentals of Risk Management

• Emco Maier, 24 hour training course

CNC Operation

• Flow International Corporation

Intensifier pump and maintenance

Ultra-High Pressure Water Jet Maintenance and Flow Master Control

Contact this candidate