Mark Sullivan

**** ***** ******* ** addyg9@r.postjobfree.com

Apt 52 https://www.linkedin.com/in/mark-d-sullivan Rolla, MO 65401 001-573-***-****

OBJECTIVE: Full-time job as entry level Controls or Automation Engineer, starting summer, 2020.

EDUCATION: Missouri S&T, Certificate in PLC and Automation current, GPA 4.0 Stanford University, Certificate in Guidance April 2019 and Control GPA 3.4

Ohio State University

BS Electrical Engineering GPA 3.59

Ohio State University

MS Electrical Engineering GPA 3.8

University of Missouri

BS Mechanical Engineering GPA 3.3

COURSES:

Feedback Control Control System Design

Basic PLC Motion Control PLC

Digital Control Controls Lab

Graduate Dynamics Process Control

EXPERIENCE:

Maxim, Beaverton, Oregon, fabrication operator, 2018 – 2020 Loaded Silicon wafers into plasma furnaces, input commands to control interface. Intel, Hillsboro, Oregon, yield department, 2011 – 2016 Found defects in manufacturing process, wrote reports. ElectroScience Lab, Ohio State University, Graduate Research Assistant, studied signal propagation for wireless systems, built and tested antenna in test range. SKILLS:

Control System Design Programmable Logic Controller Human-Machine Interface (HMI) Matlab and Simulink

C++ Fortran

Siemens TIA Portal Rockwell Studio 5000

AutoCad Latex

Cadence SPICE

Vissim Intermediate Swedish Language

PROJECTS:

Designed and built analog controller for DC motor speed control. Determined transfer function amplitude and phase of motor system. Built controller from opamp circuits. Designed and implemented digital controller for DVD drive. Used Labview to produce controller which met step response requirements.

Used Siemens S7 PLC (TIA Portal) to control conveyor, implemented measurement steps, diversion to reject or accept bins.

Used Allen-Bradley PLC to implement PID (proportional-integral-derivative) controller in lab exercise.

Set up HMI using Allen-Bradley ladder logic to control automatic storage and retrieval system. Wrote Motion Control logic for rotary knife cam profile controlled by Siemens PLC. Wrote Motion Control using Allen-Bradley ControlLogix (Studio 5000) for x-y gantry including safety relay, and for Deltabot motion.

Class final project to design state variable controller for aircraft attitude and simulate result in Matlab.

HONORS and ACTIVITIES:

Eta Kappa Nu Electrical Engineering Honor Society

Tau Beta Pi Engineering Honorary

W8LT Ohio State amateur radio club

Ohio State Soccer Club

Sports writer, “Missouri Miner” campus newspaper

Contact this candidate