AMANDEEP KAUR

***** ****** ** *****: 510-***-****

Hayward, CA 94544 Email: acqgqc@r.postjobfree.com

EDUCATION

B.S. Electrical Engineering A.S. Mathematics

UC San Diego, Graduated: March 2015 Chabot Community College, Hayward, CA

Cumulative GPA: 3.13 Graduated: May 2012, GPA: 3.80

Relevant Coursework:

Linear Systems Fundamentals Microwave Systems & Circuits

Digital Integrated Circuit Design Introduction to Power Electronics

Analog Integrated Circuit Design Digital Signal Processing I

INTERNSHIP EXPERIENCE

Hardware Engineering Intern

Seacomp, Carlsbad, CA April 2014- Sept 2014

• Used Altium CAD tools to build schematic and laying out PCB design of display projects

• Prototyped and tested FReal Cape LCD display sub-circuit to enable read/write onto the chip

• Prototyped and tested backlight driver circuit

• Obtained experience using industrial soldering tools to solder and DE solder the compo nents of integrated circuits on PCB

Advanced Manufacturing Intern

Combined Power, Santee, CA Jan 2014- March 2014

• Built and tested the low-pass RC filter to reduce the noise in the signal to read the flow of water

• Soldered the low-pass RC filter to the input wire to suppress the noise caused by higher frequencies

• Polished the back side of the mirrors with coating to prevent them from corroding in water

PROJECT EXPERIENCE

Datalogger

Cubic Transportation Systems, UCSD Project Jan 2015- Present

• Tested and implemented current sensor and temperature sensor to add to the mobile validator to measure the sensitivity of device

• Tested and implemented the RF signal read by two turns coil for the Amplitude modulation and measured the rise time of the signal

• Implemented band pass filter, rectifier and comparator circuits to read the input signal and card’s response in the field

• Used ExpressPCB to finish the schematic and layout of the PCB design

Carry-Skip Adder May 2014-June 2014

Digital Integrated Circuit Design, UC San Diego

• Implemented Carry-Skip algorithm to add 8 bits and reduced the worst case delay of the adder as compared to the ripple carry adder

• Finished the transistor level layout of 8-bit Carry-Skip adder using Cadence Virtuoso and also cleared off all DRC and LVS errors

Viacar Project

IEEE Project, UC San Diego Nov 2013- May 2014

• Worked on motor controller to apply PWM to control the speed of car

• Designed, tested and debugged Half-Bridge circuit to control forward, reverse and breaking functions of car

TECHNICAL SKILLS

Software Skills

Altium, ExpressPCB, ORCAD Virtuoso, MATLAB, C++, C, MS Office (Word, Excel, PowerPoint), PSpice, Simplorer

Hardware Skills

• Function Generator, Oscilloscope, DMM, Power Supply, Soldering Iron

HONORS

• Excellence award in writing- MMW Research paper, UCSD, 2012-2013

• Provost’s Honors, Winter 2013, Spring 2013

• Member of Eta Kappa Nu, Winter 2014-Present

LEADERSHIP SKILLS

• ICC Representative, Alpha Gamma Sigma Honors Society at Chabot College, Hayward, CA Jan 2012 -May 2012

• Staff Member, IEEE at UCSD, Fall 2013- Winter 2013

PERSONAL SKILLS

• US Citizen

• Writes and speaks English, Hindi and Punjabi fluently

Contact this candidate