**** ***** ***** ********** **. *****

804-***-**** FOXJR63@GMAIL,COM

JACOB FOX

OBJECTIVE

To obtain a position in the inspection industry where I can utilize my skill and experience. Provide the best service possible. Work in a safe courteous manner.

PHYSICAL CONDITION: Great physical condition with no limitations.

EDUCATION/CERTIFICATIONS

Williamsport Area High School Graduate Williamsport, PA 1981

Williamsport Are Community College Williamsport, PA 1980-1982

Certificate in Welding Technology

Pennsylvania College of Technology Williamsport, PA 1994

? Level I and II UT/MT/RT and PT per SNT-TC-1A

Pennsylvania College of Technology Williamsport, PA 1994

? Introduction to Metallurgy

AWS-CWI #96110301 Virginia 1996

API653 #6440 Tank Inspection Virginia 1998

API510 #22899 Pressure Vessel Inspection Virginia 2001

API570 #27573 Piping Inspection Virginia 2005

NBIC IS Commission #844 Virginia 2000

WORK EXPERIENCE

E.I. DuPont/Richmond, VA

Oct 2000 ? Present

Staff Inspector/Site Weld Champion

? Manage site fixed equipment mechanical integrity program consisting of approximately 1200 pieces of equipment

? Perform routine and non-routine inspections per the applicable RAGAGEP

? Maintain site NBIC Accredited Owner/User Program

? Adhere to State regulatory and corporate PSM compliance.

? Review drawings/specifications for new equipment

? Perform receipt inspections of new equipment to assure it is per the drawings/specification

? Manage two contract NDE examiner personnel

? Oversee and perform weld inspections of site weld program

? Knowledgeable in the ASME, API, and NBIC codes

MIQA/Richmond, VA

April 1997-Oct. 2000

Third Party NDE Examiner

? ASNT-TC-1A Level II in UT, PT

? NDE Responsibilities include

? Perform UT thickness surveys of piping systems and vessels.

? Perform pipe isometric field sketches; convert over to CAD, setup pipe circuit in UltraPipe? for UT analysis.

? Write and issue reports

Tampella Power/Williamsport, PA

March 1993-March 1997

Tube Fabricator III

? Performed all aspects of power and recovery boiler fabrication per ASME Sec I

? Qualified/certified welder per ASME Sec IX

? Responsible for dimensional preparation of water walls, layout of wall attachments,

? and layout/prep of header ends.

? Attached and weld headers to water walls and attach jumper tubes

Tenneco Newport News Shipbuilding/Newport News, VA

May 2011-April 2012

Nuclear Qualified/Certified Pipe Welder per Mil-189

? Held DOD Security Clearance

? Certified to weld Inconel, Monel, CU/Ni, Stainless Steel and Carbon Steel

? Provided welding Instruction to new welders

? All welds performed were 100% radiographed

REFERENCES

Paul Wyman (Materials Engineer) 804-***-****

Contact this candidate