Robert Bostick

**** *.

Independence Blvd.

Charlotte,N.C. 28205

Phone-704-

***-****

E-mail -

acedsi@r.postjobfree.com

****- ******* ***/**** ********

Charlotte,N.C. 1-Assist press operators

2- Stacker : stack all inserts on

pallets

3- Insert operator when needed

2012-2013 Con-star International ( Plastic Bottles

)

Charlotte,N.C. Material Handler

1- Check all stock in warehouse

2- Stock all machines with

preforms and labels

3-Re leave all operators on

machines for all breaks

4- RF-scan all inventory

5- Empty all trash and gay-lords

2011-2012

Charlotte,N.C.

Custom Polymers (Plastic-

Recycle)

Recondition tech.

1- Prep all plastic tubes

2- Place tubes on re-winder to

remove old film

3- Use cleaning solution to remove

excess glue

4- Place tube in box for shipping

2008-2010 Trim Systems (Truck Headliners)

States ville,N.C. Water Jet Operator

1- Check order sheet for part type

2-find setting in program

manual,Set in computer

start robot.

3-Take part hot glue pre hole base

board to headliner

to screw mount speaker parts

4- Pack/label part for shipping

2007 -2008 Flex/Sol (Plastic Bags)

Statesville,N.C.

Winder Operator

1-Assist blower operator threading

winder machine

2-Set-up my area for orders

3-Start machine up,Pull my rolls

off winder,stack on

pallets,label for shipping.

93- 2003 Accuma Corp. (Plastic)

Statesville,N.C.

Injection Molding Machine Operator

Mold Change Tech

1- Start up machine

2- Check parts for quality

3- Keep up with all production

sheets

4- Inform supervisor of any

problems,Make adjustment ifneeded

5- Pack parts on pallet for

shipping

Mold change tech.

1- Check with operator to see when

orders done

2- Clamp mold shut,kill power

3- Shut off all pumps,water,valves

4- Place eye in top of molds,Go get

overhead crane

5- Lower chains,Pull up slack.

Loosen all clamps

6- start pump,open mold,Move crane

right and left a few times

till ring breaks lose

7- Pull mold free and up/out, Now

ready for next mold

Dream Job

During my six years in the navy I worked in the

main engine room.

My job was to operate every pump/valve in the

engine room and I did

School and on the job training.

1- I had two pump I had to do (PMS) maintenance 60/90

days

500GPM-1200GPM

2- I worked and fixed gate/ globe/butterfly/check

valves

3- ran our first valve shop. Fix/sand blast

recondition and store all valve

for reuse

4-Pumps-remove pump housing,remove bearings,check

shaft,impeller blades

replace gasket reassemble pump,Test pump for

pressure,Put back in operation

Education

John F. Kennedy H.S. Bronx, New York

N.Y.

Pulson Plastic class Accuma Corp.

Valve/Pump-Repair/Maintenance School U.S.Navy

Contact this candidate