JERRY RODANTE

****-* ***** ***.

Clearwater, FL *3760

727-***-****

Email: acd0z0@r.postjobfree.com

PROFESSIONAL SKILLS

Read and comprehend electronic schematics, PWA layouts, parts lists, and test

procedures. Use oscilloscopes, DMM's, signal generators frequency counters, and other

electronic test equipment. Solder and rework electronic printed circuit cards - both

surface mount and through the hole.

PROFESSIONAL

EXPERIENCE

SEPTEMBER 2011 to APRIL 2014

LEDnovation, Tampa, FL

Production Support Tech

Employed as a contract technician by ALC Technical. Duties included supporting

production activity such as troubleshooting/repairing production failures; testing,

troubleshooting, repairing, and modifying incoming subassemblies from our vendors. I

also interfaced with engineering on new products being released to production in regards

to any production issues.

SEPTEMBER 2008 to AUGUST 2011

Advanced Systems, Clearwater, FL

Production Technician

Employed as a temporary technician by ALC Technical. Duties included

building/soldering printed circuit cards from scratch, building minor test fixtures, and

cable assemblies. Also tested, troubleshot, and repaired numerous commercial printed

circuit cards. During my final year at Advanced Systems, I tested, troubleshot, and

repaired commercial printers for Catalina Marketing at Advanced Systems while still

employed by ALC Technical.

JUNE 2008 to AUGUST 2008

Kimball Electronics, Tampa, FL

Prep Department

Production Technician

Employed as a temporary technician by Westaff. Built various minor automotive

subassemblies from blueprints. Also worked at times on some of the main build lines

hand-inserting electronic components into printed circuit cards according to the

diagrams/paperwork.

MAY 2007 to FEB 2008

Zhone Technologies, Largo, FL

Factory Service and Quality Assurance Departments

Factory Service Technician and Quality Auditor

Employed as a temporary technician by Spherion. Worked mostly in the factory service

department performing soldering update modifications and rework on commercial field

return modems. The printed circuit cards were mainly surface mount where a microscope

and lighted loop were needed to perform the upgrades.

Also worked at times in the quality department auditing residential modems which were

ready for shipment. The modems were checked for proper programming and operation;

the ancillary components were also checked against the BOM to ensure they were

correct.

APR 2006 to FEB 2007

Bausch & Lomb, Clearwater, FL

Clean Room Department

Production Technician

Employed as a temporary technician by Kelly Services. I worked in the clean room

processing lenses which are implanted during cataract surgery. The lenses are checked

for proper dimension, power, and then for visible defects under a microscope.

APR 1995 to JAN 2006

Sensidyne, Clearwater, FL

Quality Assurance and Production Departments

Electronic Technician

Initially employed as a temporary technician by TECH STAFF in the prototype testing

(hardware, software, and gas testing) of a hand-held gas detection device. Later worked

as a regular employee in the production department testing and troubleshooting the

company's products – gas detection and air sampling devices. Performed the actual

soldering on most of the repairs, both surface mount and through-the hole. Also

interfaced with engineering on proto-type units and with the quality department on

vendor related issues.

EDUCATION

Tampa Technical Institute, Tampa, FL

Associate of Science in Electronics Engineering

University of South Florida, Tampa, FL

Associate of Arts in Basic Studies

Contact this candidate